VOYAGEUR GRAND Wood Insert
R
Green Grounding
Wire
|
| Remove Screw | ||
|
|
|
| |
|
| Figure 44.4 | ||
|
| 6. Remove the screw that is holding the ground lug | ||
Figure 44.1 | ||||
| to the control plate. |
4.Remove the 2 screws at the top of the control plate. Push the bottom of the control plate to the inside of the appliance and partially remove the control plate assembly.
White Wire
Black Wire |
|
| |
Figure 44.5 | |||
| |||
| 7. Use needle nose pliers to remove the strain relief | ||
| that protects the power cord from the control plate. |
Figure 44.2
5. Locate the black and white wires that are part of the power cord and disconnect those wires from the wire harness.
Placement Slot
Blower Access
Assembly
Grille hinges | Hold Down | |
downward | ||
Bracket | ||
|
Figure 44.3
| Snap Disc Bracket | |
Remove Screws & | Blower Control Plate | |
| ||
Pull Access Assembly | Remove Screws from Hold Down | |
away from Insert | ||
Bracket and Pull Blower Assembly | ||
| ||
| Forward. Do not Remove Blower from | |
| the Hold Down Bracket |
Page 44 | September 25, 2012 |