Craftsman Full Warranty, Applications | Craftsman 316.7919 guide

CRAFTSMAN FULL WARRANTY

If this Craftsman product fails due to a defect in material or workmanship within two years from the date of purchase, return it to any Sears store, Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).

This warranty applies for only 90 days from the purchase date if this product is ever used for commercial or rental purposes. This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:

•Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.

•Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.

•Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Sears, Roebuck and Co., Hoffman Estates, IL 60179

On/Off Stop Control

Fuel Cap

Starter

Rope Grip

Shaft Grip

Shoulder Strap

Loop

Air Filter/

Muffler Cover

Primer Bulb

Muffler

Spark Plug

APPLICATIONS

As a trimmer:

•Cutting grass and light weeds.

•Edging

•Decorative trimming around trees, fences, etc. Other optional accessories may be used with this unit.

•Throttle Control

D-Handle

Shaft Housing

Convertible TM

Coupler

Line Cutting

Blade

Trimmer Attachment

INSTALL AND ADJUST THE D-HANDLE

Cutting

Hassle Free® Plus Cutting Head

Adjust

Install

1.Place D-handle over the shaft housing and onto the bottom clamp (Fig. 1). Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip.

2.Start screws with a flat- head or T-25 Torx screwdriver. Do not

tighten until handle is adjusted.

Shaft Grip	Screws

Minimum 6 it (15.24 cm)

Clamp

Fig. 1

3.While holding the unit in the operating position (Fig. 8), position the D-handle to the location that provides you the best grip.

4.Tighten the clamp screws evenly until the D-handle is secure.

INSTALLING THE TRIMMER ATTACHMENT

Prior to use, make sure trimmer attachment is installed correctly. Please refer to Operating the Convertible TM Coupler System for proper installation.

NOTE: Remove red cap or hanger from lower shaft housing prior to assembling to Convertible TM coupler