Snapper S200XKOH2761, S200XKAV2761, S200XBV32 General Operating Safety, Checks Before Starting

Page 18

Operation

Operation

Operation

General Operating Safety

Before first time operation:

Be sure to read all information in the Safety and Operation sections before attempting to operate this tractor and mower.

Become familiar with all of the controls and how to stop the unit.

Drive in an open area without mowing to become accustomed to the unit.

WARNING

Never allow passengers to ride on the unit.

Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess grease. Do not stop or park tractor over dry leaves, grass or combustible materials.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

WARNING

Do not load this zero-turn rider on a trailer or truck using two separate ramps. Only use a single ramp that is at least one foot wider than the width of the rear wheels of this rider. This rider has a zero turning radius and the rear wheels could fall off the ramps, or the rider could tip over injuring the operator or bystanders.

WARNING

Never operate on slopes greater than 17.6 percent (10°) which is a rise of 3-1/2 feet (106 cm) vertically in 20 feet (607 cm) horizontally.

Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes with a rear-mounted grass catcher.

Mow across the face of slopes, not up and down, use caution when changing directions and DO NOT START OR STOP ON SLOPE.

Checks Before Starting

Check that crankcase is filled to full mark on dipstick. See the engine Operator’s Manual for instructions and oil recommendations.

Fill the fuel tank with fresh fuel. Refer to engine manual for fuel recommendations.

Make sure all nuts, bolts, screws and pins are in place and tight.

Make sure the fuel valve is in the “ON” position.

Check the tire pressures. See Check Tire Pressures.

Make sure that the Roll Bar is adjusted in the upright position. See Raise and Lower the Roll Bar.

Adjust the seat position, and make certain you can reach all controls from operator’s position. See Seat Adjustment

Adjust the height of the mower deck to the desired position. See Mowing Height Adjustment.

16

www.SnapperPro.com

Image 18
Contents OPERATOR’S Manual Date Purchased Table of Contents Operating Safety Read the ManualChildren Slope Operation Thrown ObjectsMoving Parts Roll BAR USE Retaining WALLS, DROP-OFFS, and WaterOverhead Obstacles Fuel and Maintenance Enclosed AreasTraining PreparationOperation Towed Equipment RIDE-ON Units EmissionsIgnition System Gasoline Models Service and Maintenance Safe Handling of GasolineRoll BAR Instructions Operational WarningsInspection and Maintenance of the Roll BAR Seat Belt Safety Decals Safety Icons Safety Interlock SystemOperational Safety Checks North American Safety IconsFeatures and Controls Identification NumbersControl Functions Seat Adjustment LeverIgnition Switch Ground Speed LeversParking Brake PTO Power Take Off SwitchHour Meter / Maintenance Reminder Throttle ControlGeneral Operating Safety Checks Before StartingSeat Adjustment Seat Adjustment Suspension SeatCheck Tire Pressures Mowing Height Adjustment Foot Pedal AdjustmentTo adjust pedal position Keep roll bar in the raised position and use the seat belt Lower the roll bar only when necessary and Never remove itRaise and Lower the Roll Bar To Lower the Roll BarStarting the Engine Stopping the RiderPushing the Rider By Hand Zero Turn Driving Practice Forward Travel PracticeForward Reverse Travel Executing an End-Of-Row Zero Turn Practice Turning Around a CornerPractice Turning In Place Executing TurnsHeight of Grass MowingMowing Recommendations Tall Grass Requires Incremental CuttingMowing Methods Mulching Requires Excellent Mowing Conditions Attaching a TrailerProper Mulching Engine Speed & Ground Speed for MulchingMaintenance Schedule Safety Items Before Every SpringHours Fall Check Rider / Mower for loose hardware Fuel Filter Engine MaintenanceChecking / Adding Fuel Change Oil & FilterOil LubricationGrease Lubricating the Front CastersCheck Hydraulic Oil Level Change Hydraulic Oil FilterChange Interval Every 250 Hours Filter Part Number Servicing The Mower Blades Inspecting the Mower BladesNever weld or straighten bent mower blades Reinstalling the Mower Blades Balancing the Mower Blade NailGround Speed Control Lever Adjustment Speed Balancing AdjustmentNeutral Adjustment Parking Brake AdjustmentReturn-To-Neutral Adjustment Deck Rod Timing Adjustment Deck Leveling AdjustmentMower Belt Replacement To avoid damaging belts, do not PRY Belts Over PulleysHydraulic Pump Drive Belt Replacement Use extreme caution when removing this springBattery Maintenance Charging a Completely Discharged Battery Battery ServiceChecking Battery Voltage Jump Starting With Auxiliary Booster BatteryStarter Switch Jumper Cable Starting Vehicle Battery Jumper Cable To Ground Engine BlockTemporary Storage 30 Days Or Less StorageStarting After Long Term Storage Long Term Storage Longer Than 30 DaysTroubleshooting Chart Troubleshooting the RiderProblem Cause Remedy Troubleshooting Troubleshooting Common Cutting Problems StreakingHP Kohler SpecificationsHP Kawasaki HP Briggs & StrattonFerris Limited Warranty Tractor Mower DeckChassis

S200XKOH2761, S200XKAV2561, S200XBV32, S200X/72, S200XKAV2761 specifications

The Snapper S200 series is a versatile lineup of lawn care equipment designed for both residential and commercial landscaping needs. The models S200XKAV2761, S200X/72, S200XBV32, S200XKAV2561, and S200XKOH2761 are part of this series, offering robust features and advanced technologies to enhance mowing efficiency and user comfort.

The S200XKAV2761 stands out with its powerful engine that delivers optimal performance, ensuring efficient grass cutting even in thicker patches. It features a wide cutting deck that significantly reduces the time spent mowing larger areas. The innovative Easy Start technology allows users to start the engine with minimal effort, making it ideal for both seasoned users and newcomers to lawn maintenance.

Next, the S200X/72 model is characterized by its impressive 72-inch cutting deck, making it one of the most suitable options for commercial applications. This wider deck allows for less time spent mowing and more time enjoying a beautifully manicured lawn. The model incorporates premium ergonomic controls, ensuring that operators can maneuver the machine effortlessly while maintaining comfort during extended use.

The S200XBV32 model features a unique bagging system that captures grass clippings efficiently, reducing the need for additional cleanup after mowing. This model utilizes a two-stage air filtration system that prolongs engine life while boosting power, thus enhancing productivity without compromising performance.

The S200XKAV2561 is designed with adjustable cutting heights, allowing users to customize their mowing experience according to lawn conditions. This flexibility is crucial for maintaining a healthy lawn and adapting to seasonal growth patterns. Plus, the durable chassis construction offers enhanced stability and longevity, making it a reliable choice for various terrains.

Lastly, the S200XKOH2761 model incorporates advanced hydrostatic transmission technology, allowing for a smooth and responsive driving experience. This feature is particularly beneficial when navigating tight corners and intricate landscaping. Furthermore, the model is equipped with a heavy-duty steel frame, ensuring durability and resilience against wear and tear.

In conclusion, the Snapper S200 series provides a range of models tailored to meet diverse landscaping demands. With their powerful engines, innovative features, and advanced technologies, these machines are designed to make lawn care more efficient and enjoyable for users of all skill levels. Whether for residential use or professional landscaping, the Snapper S200 lineup is an excellent investment in maintaining a pristine outdoor space.