La Crosse Technology WS-7394U Multiple Remote Temperature Sensors, Set Up of Multiple Units

Next press and hold the “SET” key for at least three seconds. You will see then that the values will reset to the current temperature and corresponding time.

B.Multiple Remote Temperature Sensors

The WS-7394U is able to receive signals from 3 different remote sensors. These extra remote sensors can be purchased through the same dealer as this unit. A TX4U will monitor the temperature and humidity, a TX3U will monitor temperature and display the temperature on its LCD, a TX3UP will monitor the temperature via a probe for measuring soil or water temperatures and a TX6U will monitor the temperature only.

Note: When setting up multiple units it is important to insert batteries first into all the remote sensors, and in numeric sequence. Second install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes

1.Set Up of Multiple Units

a.It is necessary to remove the batteries from all units currently in operation.

b.Remove the battery covers to all remote sensors.

c.Place all remote sensors in a numeric sequential order.

d.In sequential order, install batteries following the same battery installation procedures seen in Detailed Set-Up Guide section of this manual.

e.Install batteries into the indoor weather station.

f.Follow the Detailed Set-Up Guide for programming and operating instructions.

2.Viewing and Operating with Multiple Remote Sensors

a.To view the temperature of a different remote sensor press and release the “CH” button. A shift from one “boxed” number to the next should be observed in the OUTDOOR LCD.

b.The minimum and maximum temperature of the additional remote sensor can be displayed by pressing the “OUT/+” button.

c.To reset the minimum and maximum temperature readings press and hold the “SET” button for 3 seconds and that temperature record for that remote sensor will be reset only.

15