NetCommand® Controlled Recordings
Record To Setup
Figure 8
Your TV is able to start and stop recordings automatically and send the signals from one external playback device to another external recording device. It is also able to convert digital channels and IEEE 1394 device signals to analog signals that can be recorded on NetCommand compatible analog VHS and
You can schedule the recording to take place at a later time and program the recording duration for a minimum of 30 minutes and a maximum of 6 hours (in 30 minute increments). The default is 1 hour.
When a digital recording is being made, the TV will direct the signals to the recording device using the IEEE 1394 cable. When an analog recording is being made, the TV will direct signals to the recording device.
During a recording, the TV can be powered Off. If the TV is powered On, it must be tuned to the source that is being recorded.
Figure 8. Record to screen
Copy-Protected Material
When attempting to record
Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE 1394 device, or a
To initiate recording now:
1.Press REC (record) on the TV remote.
2.Press DEVICE on the remote control to move to the Source Device section.
3.Press ADJUST 
or 
to select the source device you will record from.
4.Press ENTER to confirm selection and return to the “Record to” section.
5.In the “Record to” section, review the destination device (VCR) and duration. Change if necessary.
6.Press REC a second time to initiate recording.
Time-Delayed Recording
To initiate a
1.Press REC (record) on the TV remote.
2.Press DEVICE on the remote control to move to the Source Device section.
3.Press ADJUST 
or 
to select the source device you will record from.
4.Press ENTER to confirm your Record from selection and move to the Record to section.
5.Press ADJUST 
or 
to select the Record to device, duration time, start time (press ENTER after selecting hour, minutes and AM or PM to set the time) and day. For devices that can select channels, select the channel.
6.Select Add and press ENTER to add the recording to the record list. If your selection is successful, a confirmation message will be displayed. If you pick overlapping times, day(s), or destination devices, you will see a message stating there is a conflict.
7.To exit, press HOME after all recordings have been added.
50
