Mitsubishi Electronics WS-55517, WS-65517 manual VCR to Antenna or Wall Outlet Cable, TV back panel

Connecting VCR Video and Audio to an Antenna or Wall Outlet Cable

VCR to Antenna or Wall Outlet Cable

Figure 5

A two-way RF splitter, 3 coaxial cables, right and left audio cables and S-Video or Video cables are required. These are not included with the TV.

1.Connect the incoming cable or Antenna to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANTENNA IN on the VCR back panel.

3.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

4.To use the TV speakers with the VCR, connect a set of audio cables from AUDIO OUT on the VCR back panel to INPUT 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel. If your VCR is mono (non-stereo), connect only the white (left) cable.

5.Connect either an S-Video or Video cable from VIDEO OUT on the VCR back panel to INPUT 1 VIDEO on the TV back panel. Only one type of video cable should be connected. S-Video is recommended, if available.

6.For NetCommand® controlled recordings, connect a Video cable from VIDEO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 on the TV back panel.

7.Complete the NetCommand controlled recording connection by connecting a set of audio cables from AUDIO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

Incoming Cable 1.

IN	SPLITTER	OUT
	TWO WAY	OUT

				TV back panel
Attach
only
one
cable	S-Video
			INPUT	MONITOR OUTPUT
type		1	2	AUDIO/VIDEO 1 AU DI O 2
	recommended

		if available	S-VIVIDEODEO
		5.	6.
			VIDEO					2.
			AUDIO-
		White		White
			LEFT/
			(MONO)
2.		4. Red	AUDIO-	VCR back panel
				Red
			RIGHT
			7.	HS-U748		4. Red
3.
						White
	3.			If your VCR has a video channel	5.	5.	6.	7.
		DVI	O	or RF ON/OFF switch, set it to OFF.
			T/
		Di g ita	O)
							W	R
		Di g ita	T
							h	e
			O			Attach
	ANT-1						i	d
	MAIN					only	t
		Cab leCARD S LOT				one	e
	– (DTV/CABLE /VHF/UHF) –					cable
				S-Video		type
				recommended
				if available

Figure 5. Connecting a VCR to an Antenna or Wall Outlet Cable

Note:NetCommand® will assume your VCR is connected to inputs as shown here. If you use any other inputs for your VCR or add a second VCR, this change must match in the NetCommand system. See Edit NetCommand... pages 35-42for more information.

IMPORTANT

Additional connection cables are not provided with the TV. They are available at most electronic stores.

17