Mitsubishi Electronics WS-73517 For antennas with twin flat lead, For antennas with coaxial lead

Connecting a Single Analog Antenna or Separate UHF and VHF Antennas

Single Antenna (not for use with CableCARD™)	Separate UHF and VHF Antennas
Figure 3	Figure 4
A 300-Ohm to 75-Ohm transformer is required. This is not	A UHF/VHF combiner is required. This is not included with
included with the TV.	the TV.

For antennas with twin flat lead

1.For antenna with twin flat leads, connect the

300-Ohm twin leads to the 300-Ohm to 75-Ohm transformer.

2.Push the 75-Ohm side of the transformer onto ANT-1 MAIN on the TV back panel.

For antennas with coaxial lead

3.Connect the coaxial lead directly to ANT-1 MAIN on the TV back panel.

300-Ohm	75-Ohm
FlatTwin	Coaxial
Lead	Cable

1.Connect the UHF and VHF antenna leads to the UHF/VHF combiner.

2.Push the combiner onto ANT-1 MAIN on the TV back panel.

VHF Antenna	UHF Antenna
(Channels 2-13)	(Channels 14-69)

Flat Twin Lead

Flat Twin Lead

External Antenna or Cable

TV back panel (section detail)

300 Ohm to
75 Ohm				ANT-2		ANT-1
Combiner					AUX	MAIN
UHF		SERVICE					DIGITAL
			IEEE1394
							AUDIO
VHF	2.	PORT	INPUT/OUTPUT				CableCARD SLOT

– (DTV/CABLE /VHF/UHF) –

Back Side

3.

				ANT-2		ANT-1
					AUX	MAIN
			E1394
			OUTPUT
	2.			– (DTV/CABLE /VHF/UHF) –
1.
		TV back panel (section detail)
Optional 300-Ohm
to 75-Ohm

Matching Transformer

DIGITAL

AUDIO

CableCARDTM SLOT

1.

Figure 4. Connecting separate UHF and VHF Antennas

Figure 3. Connecting an Antenna

Mitsubishi strongly recommends against using antennas with twin flat leads. Twin flat lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

16