Setup Menu, continued
Convergence, continued
Figure 10
When the Red and Blue crosshairs are properly converged, the 
, 
, 
or 
to move the Red and Blue crosshairs. Press VIDEO to switch between Red and Blue. Press AUDIO for the Advanced Convergence screen.
Red
Press ADJUST to converge the lines.
Press VIDEO to switch from Red to Blue.
Press MENU to go back.
Press CANCEL to delete changes.
Press AUDIO for Advanced Convergence.
Figure 10. Red Convergence Menu
Advanced Convergence
Figure 11
After adjusting the Red Convergence and Blue Convergence, you can
1.Move the flashing bracket to a position needing adjustment by pressing ADJUST 
, 
, 
or 
.
2.Press ENTER to select the position (flashing will stop).
3.Move the Red or Blue line by pressing 
, 
, 
or 
.
4.Press ENTER to deselect the position (flashing will resume), and move the brackets to the next position needing adjustment.
5.Press VIDEO to switch between the Red and Blue lines. A position is properly converged when all three lines combine to appear white.
6.When completed, press MENU or HOME to save your changes, and exit the Advanced Convergence screen.
7.You may also press INFO to display detailed instructions on using the Advanced Convergence. Then press INFO or MENU to return to the Advanced Convergence menu.
Press INFO for help
Figure 11. Advanced Convergence Menu
IMPORTANT
Although there are more than 64 line intersections, the flashing bracket only stops at 64 adjustment positions.
Reset Factory Defaults Menu
Figure 12
This allows you to reset the convergence to the original factory settings. The message “Convergence reset completed” will be displayed when the factory defaults have been restored.
WARNING: RESET CONVERGENCE TO
FACTORY DEFAULTS.
All manual changes to red and blue convergence and advanced convergence will be deleted.
Press ENTER to Reset convergence to the defaults.
Press HOME or MENU to return to the menu without resetting convergence.
Figure 12. Reset Factory Defaults Menu
58
