Mitsubishi Electronics WS-55517 Appendix H Cabinet Separation for Models WS-65517, WS-73517

Appendix H: Cabinet Separation for Models WS-65517, WS-73517

For Mitsubishi Dealers and Service Personnel Only

The cabinets for Mitsubishi projection television models WS-65517 and WS-73517 have been assembled in two pieces. These pieces may be separated to allow for easier delivery and setup. To safely separate and reattach the cabinet, follow the instructions below.

This projection television weighs over 320 pounds and has many sensitive components. Any dismantling procedure should be done by authorized Mitsubishi Dealers or Service Personnel ONLY.

2

Speaker

Grille

Connectors (CC, ZF)

3

Plastic

Covers,

Screws

1

The following operations should be performed by two people:

1.Remove the decorative Plastic Covers (2 or 4) on each side of the cabinet and then remove the exposed screws (2 or 4) on each side.

2.Remove the Speaker Grille by pulling straight off the cabinet.

3.Disconnect the connectors.

4.Carefully lift the Cabinet-Top straight up until the brackets are clear from the Cabinet-Bottom. DO NOT

use the Screen Frame bottom when lifting the Cabinet-Top.

5.Carefully place the Cabinet-Top on to the floor.

6.Once you have moved and positioned the Cabinet-Bottom to its desired location, reverse the procedure and mount the Cabinet-Top on the Cabinet-Bottom. Be sure you align the brackets properly. Keep fingers clear of all joints! Replace the screws and the decorative Plastic Covers that were removed in Step 1.

Cabinet-Top

6

Screen Frame

4

Brackets
Cabinet-Bottom	Plastic
	Covers

88