Mitsubishi Electronics WS-65517 Connecting VCR Video and Audio to a Cable Box, VCR to a Cable Box

Connecting VCR Video and Audio to a Cable Box

VCR to a Cable Box

Figure 6

A two-way RF splitter, 4 coaxial cables, right and left audio cables and an S-Video or Video cable are required. These are not included with the TV.

1.Connect the incoming cable to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANTENNA IN on the cable box back panel.

3.Connect one coaxial cable from OUT on the RF splitter to ANT-2 AUX on the TV back panel.

4.Connect one coaxial cable from OUT on the cable box to ANTENNA IN on the VCR back panel.

5.Connect one coaxial cable from ANTENNA OUT on the VCR back panel to ANT-1 MAIN on the TV back panel.

6.To use the TV speakers with the VCR, connect a set of audio cables from AUDIO OUT on the VCR back panel to INPUT 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white

cable connects to the L (left) channel. If your VCR is mono (non-stereo), connect only the white (left) cable.

7.Connect either an S-Video or Video cable from VIDEO OUT on the VCR back panel to INPUT 1 VIDEO on the TV back panel. Only one type of video cable should be connected. S-Video is recommended, if available.

8.For NetCommand® controlled recordings, connect a Video cable from VIDEO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 on the TV back panel.

9.Complete the NetCommand controlled recording connection by connecting a set of audio cables from AUDIO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

Incoming Cable 1.

IN	SPLITTER	OUT
	TWO WAY	OUT

Cable Box			4.
back panel
section		IN	OUT
				Attach				TV back panel
				only
	2.			one
				cable	S-Video			MONITOR OUTPUT
				type			INPUT
					recommended	1	2	AUDIO/VIDEO 1 AU DIO 2

if available
		S-VIDEO
7.		8.
		VIDEO		4.
	White	AUDIO-	White
		LEFT/
		(MONO)	VCR back panel
6.
	Red	AUDIO-	Red
		RIGHT
2.		9.	HS-U748	6. Red
	Y			5.
3.				White
	P b

Pr

If your VCR has a video channel

7.

7.

8.

9.

LEFT/

or RF ON/OFF switch, set it to OFF.

AU DI O

MONO)

W

R

AU DI O

Attach

h

e

RI G HT

3.

ANT-2

ANT-1

i

d

AUX

TAL

only

t

MAIN

I O

one

e

CableCARD SLOT

– (DTV/CABLE /VHF/UHF) –

cable

S-Video

type

5.

recommended

if available

Figure 6. Connecting a VCR to a Cable Box

Note: NetCommand® will assume your VCR is connected to inputs as shown here. If you use any other inputs for your VCR or add a second VCR this change must match in the NetCommand system. See Edit NetCommand... pages 35-42for more information.

18