Cub Cadet 7264 manual Main Fuse, Hazard Light Flasher Relay

Page 34

Main Fuse

The main fuse in the tractor wire harness protects the tractor’s entire electrical system. A blown main fuse will prevent battery current from passing though the harness.

To replace the main fuse:

•Raise the tractor hood and remove the right side panel.

•Locate the main fuse under the dash panel, along the tractor’s right frame rail. See Figure 40.

MAIN FUSE

FUSE HOLDER

RT. FRAME

RAIL

WIRE

HARNESS

DASH PANEL

Figure 40

•Pull the fuse from the fuse holder and replace with the same capacity fuse (30 Amp). NEVER use a higher amperage fuse.

•Install the side panel and lower the tractor hood.

Hazard Light Flasher Relay

The flasher relay controls the on/off flashing of the hazard lights. If the hazard lights do not function properly, the flasher relay is probably faulty.

Replace the relay as follows:

•Remove the dash panel insert by removing the two screws. Refer to Figure 38.

•Pull the wire harness from the dash opening. Cut and remove the electrical tape holding the flasher relay to the harness. See Figure 41

•After first noting the position of the two harness leads, disconnect the leads and replace the faulty relay with a new relay.

•Secure the relay to the wire harness with electrical tape.

•Position the wire harness in the dash panel and reinstall the dash panel insert.

 

 

FLASHER

 

 

RELAY

X

X

TAPE

X

 

X

 

 

 

 

WIRE

 

 

HARNESS

 

 

HARNESS

LEADS

Figure 41

CHECKING TRANSMISSION/HYDRAULIC SYSTEM OIL LEVEL

Check the hydro transmission/hydraulic system oil level after every 50 hours of operation. Check the oil level only while the engine is stopped and the tractor is standing on a level surface.

The oil fill plug/dipstick is located at the rear of the tractor, above the rear PTO shield. See Figure 42.

•Clean the area around the oil fill plug/dipstick to prevent debris from entering the transmission housing. See Figure 42.

•Turn the oil fill plug/dipstick counterclockwise to unscrew from the transmission housing.

•Withdraw the dipstick and wipe it clean, then reinsert and screw in all the way. Unscrew and withdraw again to read the oil level. Always keep the oil level between the add and full marks on the dipstick (See Figure 42).

OIL FILL PLUG/DIPSTICK

PTO SHIELD

Full Mark

F

A

Add Mark

Figure 42

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualCalling Service Information Table of ContentsTo the Owner Tractor Model Plate Recording Model and Serial Number InformationRops Information Plate Important Safe Operation Practices General OperationSlope Operation Do notSafety Frame Rops Safety Labels Keep HandsSafety Labels Controls and Features Floorboard and Dash Panel Mounted ControlsSeat Adjustment Lever PTO SwitchIgnition Switch Steering WheelDifferential Lock Pedal Hazard Light SwitchHeadlight Switch Parking Brake LeverBattery Indicator Light Parking Brake Indicator LightPTO Indicator Light Tachometer Engine Coolant Temperature LightFuel Fill Cap Fender Mounted Conrtols and FeaturesPTO Reverse Override Switch PTO Selection LeverHand Holds Transmission Hi/Lo Range Shift LeverCup Holder Amber Hazard LightsRollover Protective Structure Rops OperationFolding the Rops NEW Tractor BREAK-IN Procedures Safety Interlock SystemFueling the Tractor Standing beside the tractor Using Jumper Cables to Start the EngineStarting the Engine Cold Weather StartingDriving on Slopes Using the FORWARD/REVERSE PedalDriving the Tractor Stopping the TractorUsing the HI/LO Range Shift Lever Using the Differential Lock PedalUsing the Hydraulic Lift Lever Using the PTO Selection LeverLighting Using the PTO Reverse Override SwitchEngaging the PTO Headlights and TaillightsHazard Lights Using the Hitch PlateUsing the Three Point Hitch On Demand Four Wheel DriveWeighting the Rear of the Tractor Tractor WeightingFront Weights Rear Weight BoxAdjusting the Seat Belt AdjustmentsAdjusting the Seat Three Point Hitch AdjustmentsAdjusting Front Wheel TOE-IN Check the TOE-IN AS FollowsAdjusting the Brakes Adjusting Hydraulic Lift Feedback RODMaintenance General InformationLubrication and Maintenance Chart Illustration Lubrication and Maintenance Chart Accessing the Engine Compartment General Battery InformationBattery Maintenance Battery RemovalBattery Storage Tail Light Bulb Replacement Head Light Bulb ReplacementHazard Bulb Replacement Servicing Electrical System Instrument Panel Bulb ReplacementAccessing the Fuse Center Instrument Panel FusesHazard Light Flasher Relay Main FuseChecking TRANSMISSION/HYDRAULIC System OIL Level Changing TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter Change Check Final Reduction Gear Case Oil Check Front Axle OilChanging Front Axle and Final Reduction Gear Case OIL Lubrication of FWD Drive Shaft Maintenance of the Rollover Protective Structure RopsLubrication of Main Drive Shaft Wheel Bolt TorqueTire Maintenance Tractor StorageRemoving the Tractor from Storage Engine Information and Maintenance Daihatsu Emission Control Defects Warranty CoverageIgnition System Cleaning the Radiator Screen and Radiator Engine MaintenanceCleaning the Engine Before servicingAdding Engine OIL Changing the Engine OIL and FilterChecking Engine Coolant Level Inspection of Cooling System Hoses Changing the AIR CleanerChanging the Engine Coolant Servicing the Fuel Filter Draining The Fuel Filter CupChanging The Fuel Filter Specifications Hydraulic Lift System Power Take-OffGeneral Dimensions BrakesOptional Equipment and Accessories DescriptionCUB Cadet LLC Post Office BOX CLEVELAND, Ohio

7264 specifications

The Cub Cadet 7264 is a powerful lawn tractor that stands out in the market for its robust performance and innovative features. Designed for both residential and commercial use, this machine combines efficiency, durability, and user-friendly technology, making it an ideal choice for anyone looking to maintain a pristine lawn.

One of the key characteristics of the Cub Cadet 7264 is its reliable engine. Equipped with a Cub Cadet 726cc engine, it delivers ample power to handle tough mowing conditions. The engine is designed for optimal fuel efficiency and low emissions, ensuring that users can operate the mower while being mindful of their environmental impact.

The mower features a cast-iron front axle, providing strength and stability, which is crucial when tackling uneven terrain. This durability is complemented by the heavy-duty steel frame construction, ensuring that the Cub Cadet 7264 can withstand the rigors of regular use. The design also incorporates a responsive hydrostatic transmission that allows for seamless speed adjustments, enabling the operator to navigate tight spaces and challenging landscapes with ease.

One of the standout features of the Cub Cadet 7264 is its 42-inch cutting deck, which is equipped with optimized airflow for superior grass cut quality. The cutting deck height can be easily adjusted, offering six different positions to cater to various grass types and cutting preferences. The mower also has a dual blade system that enhances cutting performance, ensuring a clean and even finish with every pass.

Technologically, the Cub Cadet 7264 brings modern convenience to lawn maintenance. It features a comfortable high-back seat with ergonomic support, allowing for extended use without discomfort. The intuitive controls are designed for ease of use, with a dashboard that displays essential information like fuel level and engine temperature, keeping the user informed at all times.

For added convenience, the mower comes equipped with a removable debris shield, making it easy to clean after use. The optional attachments, including baggers and mulchers, further enhance its versatility, allowing users to manage grass clippings efficiently.

In conclusion, the Cub Cadet 7264 is a remarkable lawn tractor packed with features aimed at delivering exceptional performance and user convenience. With its powerful engine, durable construction, efficient cutting capabilities, and modern technologies, it stands as an excellent choice for homeowners and landscapers alike who seek a reliable mowing solution.
Top Page Image Contents