Cub Cadet 7264 manual Tire Maintenance, Tractor Storage

Page 39

TIRE MAINTENANCE

Check the tire air pressure after every 50 hours of operation or weekly. Keep the tires inflated to the recommended pressures. Improper inflation will shorten the service life of a tire. See the tire side wall, or the Tire Inflation chart, for proper inflation pressures. Observe the following guidelines:

• Do not inflate a tire above the maximum

pressure shown either on the sidewall of the

•Place the tractor on a firm, level surface and position jack stands to support the raised tractor while repairing tires.

•DO NOT place any part of your body beneath the tractor or start the tractor engine while the tractor is raised off the ground with a jack.

TIRE INFLATION CHART

tire or the Tire Inflation chart.

• Do not reinflate a tire that has been run flat or

seriously under inflated. Have a qualified tire

mechanic inspect and service the tire.

WARNING: Servicing tires can be dan- gerous. Whenever possible, trained personnel should service and mount tires.

Position

Front

Rear

Front

Rear

Front

Rear

Tread Type

Turf

Turf

Ag

Ag

Indus.

Indus.

Tire Size

23x 9.5-12

31 x 12-15

6-12

8.3-16

8.5-12

10-16.5

Inflation Pressure

10psi

15psi

20psi

22psi

35psi

45psi

If you must service the tires, observe the following safety precautions to avoid an injury or fatality:

•Make certain the rim is clean and free of rust.

•Lubricate the flanges of the rim and beads of the tire with soap solution.

•WHEN SEATING THE BEADS, NEVER INFLATE A TIRE OVER 35 PSI. If the tire beads have not seated at or before 35 PSI, allow the tire to deflate. Reposition the tire on the rim, lubricate the tire beads and rim flanges, and reinflate until seated - up to a maximum of 35 PSI. Inflating a tire with unseated beads beyond 35 PSI could break the bead or rim with sufficient explosive force to cause a serious injury.

•After the beads have seated, adjust the infla- tion pressure to the recommended operating pressure.

•Do not use a damaged rim, or attempt to repair a rim by brazing, welding, or pounding out.

•Make certain the jack used to raise the tractor has a weight capacity adequate for lifting the tractor.

TRACTOR STORAGE

If your tractor is not going to be operated for an extended period of time (thirty days to approxi- mately six months), the tractor should be prepared for storage. Store the tractor in a dry and protected location. If stored outside, cover the tractor (includ- ing the tires) to protect it from the elements. The procedures outlined below should be performed whenever the tractor is placed in storage.

WARNING: Never store the tractor with fuel in the tank indoors or in poorly ventilated enclosures, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer, etc.

1.Change the engine oil and filter following the instructions provided in CHANGING THE ENGINE OIL AND FILTER in SECTION 5.

2.Drain and flush the cooling system. Refill with a minimum 50/50 antifreeze and water coolant solution. Use a higher percentage of antifreeze if the tractor will be subjected to temperatures below minus 30° F.

39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyTable of Contents Calling Service InformationTo the Owner Recording Model and Serial Number Information Tractor Model PlateRops Information Plate General Operation Important Safe Operation PracticesDo not Slope OperationSafety Frame Rops Keep Hands Safety LabelsSafety Labels Floorboard and Dash Panel Mounted Controls Controls and FeaturesSteering Wheel PTO SwitchIgnition Switch Seat Adjustment LeverParking Brake Lever Hazard Light SwitchHeadlight Switch Differential Lock PedalEngine Coolant Temperature Light Parking Brake Indicator LightPTO Indicator Light Tachometer Battery Indicator LightPTO Selection Lever Fender Mounted Conrtols and FeaturesPTO Reverse Override Switch Fuel Fill CapAmber Hazard Lights Transmission Hi/Lo Range Shift LeverCup Holder Hand HoldsOperation Rollover Protective Structure RopsFolding the Rops Safety Interlock System NEW Tractor BREAK-IN ProceduresFueling the Tractor Cold Weather Starting Using Jumper Cables to Start the EngineStarting the Engine Standing beside the tractorStopping the Tractor Using the FORWARD/REVERSE PedalDriving the Tractor Driving on SlopesUsing the Differential Lock Pedal Using the HI/LO Range Shift LeverUsing the PTO Selection Lever Using the Hydraulic Lift LeverHeadlights and Taillights Using the PTO Reverse Override SwitchEngaging the PTO LightingOn Demand Four Wheel Drive Using the Hitch PlateUsing the Three Point Hitch Hazard LightsRear Weight Box Tractor WeightingFront Weights Weighting the Rear of the TractorThree Point Hitch Adjustments AdjustmentsAdjusting the Seat Adjusting the Seat BeltCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting Hydraulic Lift Feedback ROD Adjusting the BrakesGeneral Information MaintenanceLubrication and Maintenance Chart Illustration Lubrication and Maintenance Chart General Battery Information Accessing the Engine CompartmentBattery Removal Battery MaintenanceBattery Storage Head Light Bulb Replacement Tail Light Bulb ReplacementHazard Bulb Replacement Instrument Panel Fuses Instrument Panel Bulb ReplacementAccessing the Fuse Center Servicing Electrical SystemMain Fuse Hazard Light Flasher RelayChecking TRANSMISSION/HYDRAULIC System OIL Level Changing TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter Change Check Front Axle Oil Check Final Reduction Gear Case OilChanging Front Axle and Final Reduction Gear Case OIL Wheel Bolt Torque Maintenance of the Rollover Protective Structure RopsLubrication of Main Drive Shaft Lubrication of FWD Drive ShaftTractor Storage Tire MaintenanceRemoving the Tractor from Storage Daihatsu Emission Control Defects Warranty Coverage Engine Information and MaintenanceIgnition System Before servicing Engine MaintenanceCleaning the Engine Cleaning the Radiator Screen and RadiatorChanging the Engine OIL and Filter Adding Engine OILChecking Engine Coolant Level Changing the AIR Cleaner Inspection of Cooling System HosesChanging the Engine Coolant Draining The Fuel Filter Cup Servicing the Fuel FilterChanging The Fuel Filter Specifications Brakes Power Take-OffGeneral Dimensions Hydraulic Lift SystemDescription Optional Equipment and AccessoriesCLEVELAND, Ohio CUB Cadet LLC Post Office BOX

7264 specifications

The Cub Cadet 7264 is a powerful lawn tractor that stands out in the market for its robust performance and innovative features. Designed for both residential and commercial use, this machine combines efficiency, durability, and user-friendly technology, making it an ideal choice for anyone looking to maintain a pristine lawn.

One of the key characteristics of the Cub Cadet 7264 is its reliable engine. Equipped with a Cub Cadet 726cc engine, it delivers ample power to handle tough mowing conditions. The engine is designed for optimal fuel efficiency and low emissions, ensuring that users can operate the mower while being mindful of their environmental impact.

The mower features a cast-iron front axle, providing strength and stability, which is crucial when tackling uneven terrain. This durability is complemented by the heavy-duty steel frame construction, ensuring that the Cub Cadet 7264 can withstand the rigors of regular use. The design also incorporates a responsive hydrostatic transmission that allows for seamless speed adjustments, enabling the operator to navigate tight spaces and challenging landscapes with ease.

One of the standout features of the Cub Cadet 7264 is its 42-inch cutting deck, which is equipped with optimized airflow for superior grass cut quality. The cutting deck height can be easily adjusted, offering six different positions to cater to various grass types and cutting preferences. The mower also has a dual blade system that enhances cutting performance, ensuring a clean and even finish with every pass.

Technologically, the Cub Cadet 7264 brings modern convenience to lawn maintenance. It features a comfortable high-back seat with ergonomic support, allowing for extended use without discomfort. The intuitive controls are designed for ease of use, with a dashboard that displays essential information like fuel level and engine temperature, keeping the user informed at all times.

For added convenience, the mower comes equipped with a removable debris shield, making it easy to clean after use. The optional attachments, including baggers and mulchers, further enhance its versatility, allowing users to manage grass clippings efficiently.

In conclusion, the Cub Cadet 7264 is a remarkable lawn tractor packed with features aimed at delivering exceptional performance and user convenience. With its powerful engine, durable construction, efficient cutting capabilities, and modern technologies, it stands as an excellent choice for homeowners and landscapers alike who seek a reliable mowing solution.
Top Page Image Contents