CAUTION
Too much oil can cause the engine to over- heat. Signs include but are not limited to the following: a decrease in engine perfor- mance, oil leaking from the governor arm, an oil seal, or the air filter.
To correct this, immediately drain the oil from the engine and make sure you are us- ing the correct amount of oil as shown pre- viously.
ÎSTEP 2:
Before starting the engine, move the
CHOKE lever to the CHOKE position as indicated.
After engine has warmed and idles smoothly, move CHOKE lever to the RUN position as indicated.
Warm engine starting:
Move the CHOKE lever to the CHOKE position as indicated in the previous step. Once you have achieved stable idle, move CHOKE lever back to RUN position.
ÎSTEP 3:
Connect the high pressure hose to the unit’s high pressure outlet.
ÎSTEP 4:
Connect garden hose to unit’s water in- let.
ÎSTEP 5:
Connect garden hose to the cold water source and turn water on completely. Do not use hot water.
ÎSTEP 6:
If the trigger gun safety lock is engaged, please disengage.
Hold the trigger gun open until all trapped air is eliminated from the low pressure water stream.
ÎSTEP 7: Check oil level.
Please see STEP1 for details on min/ max levels
ÎSTEP 8:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline. Do not mix oil into the gasoline.
English 7