BEFORE STARTING
Read and understand all Important Safety Instructions in the front of this manual and the following Cautions and Warnings before starting the pressure washer.
•Never fill fuel tank completely. Fill tank to 1/2" below bottom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.
•Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.
•Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust con- tains carbon monoxide, an odorless and deadly gas.
•Never turn water supply off while pressure washer engine is running or damage to pump will result.
•DO NOT use hot water, use cold water only.
•DO NOT stop spraying water for more than two minutes at a time.
NOTE: Remove and discard blue plug in fuel fill.
Fuel
Fill
1.Add fresh high quality unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine.
2.Remove filler cap/dipstick and add engine oil (supplied) to
engine.
NOTE: There will be a slight amount of oil in the engine from factory testing.
3.Oil level should be at the FULL line on dipstick. Always check oil level before each
Filler cap/ dipstick
4.Verify the filter screen is in water inlet of pump, as shown.
Filter Screen
5.Connect high pressure hose to pump outlet.
6.Connect water source to pump inlet.
NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.
High
WaterPressure
SourceHose
13- ENG | D30339 |
| D30339 |