Craftsman 919.672180, D30339 To Change Oil, To Remove, To Clean, Clean and Replace Spark Plug

Page 16

To Change Oil

Drain the engine oil when the engine is warm. Warm oil drains quickly and completely.

1.	Before tipping engine or
	equipment to drain oil, drain fuel
	from tank by running engine until
	fuel tank is empty.
2.	Disconnect spark plug wire and
	keep it away from spark plug.
3.	With engine OFF but still warm
	remove filler cap/dipstick.
4.	Place a suitable container next
	the engine to catch the used oil.

Air Cleaner

To Remove

1.Loosen screw and tilt cover down.

2.Remove air cleaner.

3.Reinstall clean (or new) air cleaner assembly inside cover. Lip of pre-cleaner must be at bottom of cartridge pleats.

4.Insert cover’s tabs into slots in bottom of base.

5.Tilt cover up into place and tighten screw.

5. Keeping air cleaner above oil

outlet, drain oil.

Air Cleaner

Drain Oil

Cartridge Cartridge Lip

Pre-

Cleaner

Tabs and Slots

Base

NOTE: Please dispose of used motor oil in a manner that is compatible with the environment. It is recommended to take used oil in a sealed container to your local recycling center or service station for reclamation. Do not throw it in the trash or pour it on the ground or down a drain.

6.With the engine in a level position, fill to the FULL line on the dipstick with SAE 10W-30 oil. Engine oil capacity is 20 oz. (0.6

liter).

NOTE: Other viscosities shown in the chart in the “To Check Oil” paragraph may be used.

7.Replace the oil filler cap/dipstick securely.

Cover

Pre-Cleaner Lip	Screw

To Clean

Separate pre-cleaner from cartridge and wash in liquid detergent and water. Air dry thoroughly. Do not oil. Reassemble dry pre-cleaner on clean cartridge.

Do not use pressurized air or solvents to clean cartridge. Pressurized air can damage cartridge; solvents will dissolve cartridge.

Clean and Replace Spark Plug

Change the spark plug every 100 hours of operation or once each year, whichever comes first. This will help your engine to start easier and run better.

.030” (0.76 MM)

Wire Gauge

Resistor

16- ENG

D30339

Image 16

Contents Pressure Washer Table of Contents Specification Chart Safety Guidelines DefinitionsModel No 919.672180 Pressure Washer EngineRisk of Explosion or Fire Maintenance InstructionsRisk to Breathing Risk to Fluid Injection Risk of Chemical BurnRisk of Electrical Shock Risk of Unsafe OperationRisk of HOT Surfaces Risk of Injury from Spray Carton Contents AssemblyRemove Loosen Operation Throttle Control Lever Controls engine speedPressure Washer Terminology HOW to Apply Chemicals and Cleaning Solvents To Apply chemicalsBefore Starting Maintenance Maintenance Task Customer Responsibilities TableEngine Pressure WasherTo Clean Clean and Replace Spark PlugTo Change Oil To RemovePump Storage Engine PreparationTroubleshooting Guide Problem Cause CorrectionIs a steady stream Problem Cause Correction Pressure Washer Model Number Repair PartsKey# Description Torque to 50 70 IN-LBS Not ShownPressure Pump Model Number D28703 Key# Part# Description Briggs & Stratton Engine Model Number 128812-3112-D2Assemblies include all parts shown in frames Spring-Valve Intake Screw Engine Sump 691636 Screw 137 693981 Terminal-Sparkplug Kit-Screw/Washer Air Cleaner Primer Blower Housing Pawl Friction Plate Part# Garantie Complète DE UN AN SUR LES Laveuses À Pression Table DES MatièresSears Canada, Inc., Toronto, Ont. M5B 2B8 Tableau DES Spécifications Mesures DE Sécurité DéfinitionsRenseignements SUR LA Sécurité DU Consommateur De modèle 919.672180 Laveuse à pressionRisque Dexplosion OU D’INCENDIE Prévention Mesures DE Sécurité ImportantesRisque PAR Inhalation Prévention Risque Prévention Dincendie ou des problèmes aux voiesRisque Dune Utilisation NON Sécuritaire Prévention RisqueRisque DE Blessures PAR Vaporisation Contenu DE LA Boîte AssemblageRetirer Desserer Utilisation Familiarisez-vous avec votre laveuse à pressionLaveuse À Pression MoteurTerminologie DES Laveuses À Pression UtilisationRéglage DE LA Pression Utilisation DE LA LanceArrêt DE LA Laveuse À Pression Application DES Produits CHIMIQUES/SOLVANTS DE NettoyageApplication de produits chimiques Avant LE Démarrage Mise EN GardeEntretien Mouvement qui peuvent causer des blessures graves ou la mortTableau DES Responsabilités DU Client Tache D’ENTRETIENVérification du niveau d’huile MoteurNettoyage et remplacement de la bougie d’allumage Changement de l’huileFiltre à air RetraitNettoyage DE LA Buse PompeNettoyage des débris Entreposage Préparation du moteurGuide DE Dépannage Problème Cause Correction53- FR Csga De modèle de la laveuse à pression ’article De pièce DescriptionNon illustré De modèle de la pompe refoulante D28703 De modèle du moteur Briggs & Stratton 128812-3112-D2 Pièce Description 691455 RemarqueDescription ’article pièce De flotteur Pièce Description 187 691050 Canalisation de 670 692294 613 691340 691992 Moteur’article Pièce Description Pièce Description 299819 Joint d’huile Get it fixed, at your home or ours