Craftsman D30339 Customer Responsibilities Table, Maintenance Task, Engine, Pressure Washer

CUSTOMER RESPONSIBILITIES TABLE

	Before	Every 25	Every 50	Every 100
		hours or	hours or	hours or
MAINTENANCE TASK	each use
		yearly	yearly	yearly
ENGINE
check oil level	X
change oil			X*
check air cleaner		X**
clean/replace spark plug				X
clean debris	X
clean air cooling system				X
clean combustion chamber				X

*Change oil after first 5 to 8 hours of use, then every 50 hours or every season. Change oil every 25 hours when operating the engine under heavy load or in high temperatures.

**Clean more often under conditions of dust or airborne debris. Replace air cleaner parts, if very dirty.

PRESSURE WASHER

check/clean inlet screen	X
check high pressure hose	X
check soap and chemical	X
hose and filter
check gun and wand for leaks	X
prepare for storage	Prepare unit for storage if it is to remain idle for longer
	than 30 days

ENGINE

To Check Oil

1.Shut down engine and place on a level surface.

2.Remove filler cap/dipstick and wipe it clean.

3.Replace and tighten dipstick. Remove and check oil level.

4.Oil level should be at the FULL line on dipstick.

Filler cap/ dipstick

5.If needed, add oil slowly and

recheck. Do not over fill.

NOTE: Use a high quality detergent oil classified “For Service SF, SG, SH, SJ” or higher, such as SAE 30.

NOTE: Other viscosities shown in the chart may be used when the average temperature in your area is within the recommended range.

SAE Viscosity Grades

**

*

Synthetic 5W-30, 10W-30

F -20	0	20	32 40	60	80	100
C -30	-20	-10	0	10	20 30	40

STARTING TEMPERATURES RANGE

ANTICIPATED BEFORE NEXT OIL CHANGE

6.Replace filler cap/dipstick.

15- ENG D30339