Craftsman D30339, 919.672180 owner manual Troubleshooting Guide, Problem Cause Correction

6.Pull engine starter rope slowly several times until antifreeze or windshield washer fluid comes out of high pressure hose con- nection of pump.

7.Remove short hose from water inlet of pump.

8.Install spark plug into spark plug hole and tighten securely, then reconnect spark plug wire.

9.Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer handle.

10.Drain all water from spray gun and wand by holding spray gun in a vertical position with nozzle end pointing down and squeezing trigger. Store in gun/hose holder.

11.Store chemical hose, high pressure hose, spray gun, and wand so they are protected from damage, such as being run over.

TROUBLESHOOTING GUIDE

PROBLEM		CAUSE		CORRECTION
Engine will not	1.	No fuel.	1.	Add Fuel.
start	2.	Pressure builds up after	2.	Squeeze gun trigger to
		two pulls on the recoil		relieve pressure.
		starter or after initial use.
	3.	Not choked.	3.	Choke engine, place
				engine in the choke
				position.
	4.	Spark plug wire not	4.	Attach spark plug wire.
		attached.
	5.	Choke lever in the	5.	Move choke to the "No
		"Choke" position on a		Choke" position.
		"hot" engine or an engine
		that has been exposed to
		thermal heat for a long
		period of time.
No or low	1.	Wand not in high	1.	See How to Use Spay
pressure
		pressure.		Wand paragraph in the
(initial use)				Operation Section.
	2.	Low water supply.	2.	Water supply must be at
				least 5 GPM @ 20 PSI.
	3.	Leak at high pressure	3.	Repair leak. Apply sealant
		hose.		tape if necessary.
	4.	Nozzle obstructed.	4.	Clean nozzle with paper
				clip or nozzle cleaning
				tool, pour water into noz-
				zle end to flush out ob-
				struction.
	5.	Water filter screen	5.	Remove and clean filter.
		clogged.

D30339 19- ENG D30339