Delta D28650, D3500K Read and Understand ALL Warnings Before Starting Unit, To Apply chemicals

Page 13

HOW TO APPLY CHEMICALS AND CLEANING SOLVENTS

Applying chemicals or cleaning solvents is a low pressure operation. NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.

To Apply chemicals:

1.Press chemical hose onto barbed fitting located near high pressure hose connection of pump as shown.

2.Place other end of chemical hose with filter on it into container holding chemical/cleaning solution. NOTE: The chemical/water ratio is 7:1, for every 7 gallons of water pumped 1 gallon of chemical/cleaning solution will be used.

3.Install low pressure (black) nozzle into quick connect fitting of spray wand, see How To Use Spray Wand paragraph in this section.

Barbed

Fitting

4.After use of chemicals, place chemical hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly. If chemicals remain in the pump it could be damaged. Pumps damaged due to chemicals will not be covered under warranty.

NOTE: Chemicals and soaps will not siphon when spray wand is in the high pressure setting.

READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT

When using the high pressure setting, DO NOT allow the high pressure spray to come in contact with unprotected skin,

eyes, or with any pets or animals. Serious injury can occur.

Your washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!

NEVER fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.

NEVER fill fuel tank completely. Fill tank to 1/2" below bottom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.

NEVER run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.

DO NOT let hoses come in contact with very hot engine muffler during or immediately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.

NEVER pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.

DO NOT use hot water, use cold water only.

NEVER turn water supply off while pressure washer engine is running or damage to pump will result.

DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.

If you do not understand these precautions, please call 1-866-422-4286to speak to a service representative for further instructions.

13- ENG

D28650

Image 13
Contents Struin Ction MAN UAL Consumer Safety Information Safety Guidelines DefinitionsOr serious injury Or moderate injury Death or serious injuryMaintenance Instructions Important Safety InstructionsRisk of Explosion or Fire Risk to BreathingRisk of Chemical Burn Risk to Fluid InjectionRisk of Electrical Shock Risk of Unsafe OperationRisk of HOT Surfaces Read and understand all safety warnings Consumer General and Service InformationRisk of Injury from Spray Carton Contents Assembly Instructions ENG D28650 Throttle Control Lever Controls engine speed Operating InstructionsPressure Washer Terminology Pressure AdjustmentsTo USE Spray Wand To Apply chemicals Read and Understand ALL Warnings Before Starting UnitDepress trigger on gun to start water flow. Note If applying a chemical or cleaning solution, seeTurn water source off How To Change Pump Oil MaintenancePump OIL Chart Pump Type OIL Type Capacity To Check OilNozzle Cleaning Storage Problem Trouble Shooting GuideCausecorrection Problem Cause Correction Responsibility of Original Purchaser initial User WarrantyAnualm DE Instruccio NES Información DE Seguridad Para EL Consumidor Definiciones DE Normas DE SeguridadLesiones serias Resultar en lesiones menores o Moderadas Lesiones serias Causar daños en la propiedadRiesgo Importantes Instrucciones DE SeguridadQUÉ Puede Ocurrir Cómo PrevenirloRiesgo DE Inyección DE Fluido Riesgo DE Funcionamiento Inseguro Lea y comprenda todas las advertencias de seguridad Información General Y DE Servicio Para EL ConsumidorContenido DE LA Caja Instrucciones Para EL Armado La lavadora a presión Elementos Básicos DE UNA Lavadora a Presión Instrucciones DE FuncionamientoElementos Básicos DEL Motor Características DE Funcionamiento DE SU Lavadora a Presión Terminología DE LA Lavadora a PresiónRegulación DE LA Presión Recalentamiento le ocasionará daños a la bombaCambio de boquillas USO DE LA Varilla RociadoraMarcha. Detenga el motor antes de cambiar las boquillas Como UN Simple CORTE! ¡Consulte inmediatamente a un médico Cómo Emplear Productos Químicos Y Solventes Para LimpiezaApagado ArranqueMotor no arrancase luego del segundo intento, presione el Gatillo para aliviar la presiónMotor MantenimientoBomba Gráfico DE Aceite Para LA BombaCómo Limpiar EL Filtro DE Entrada DEL Agua Limpieza DE LA BoquillaCuando SE Esperen AlmacenajeProblema Causa Corrección Guía DE Diagnóstico DE ProblemasNada o baja Del uso inicialNada o baja presión después del uso inicial continuación Goteo de aceite En la bomba ProblemaNota Responsabilidad DEL Comprador Original Usuario inicial GarantíaUidg E DE TILISATEURL’U Renseignements SUR LA Sécurité DU Consommateur Mesures DE Sécurité DéfinitionsOu la mort Des dommages à la propriétéRisque Dexplosion OU D’INCENDIE Mesures DE Sécurité ImportantesPrévention Risque PAR Inhalation PréventionRisque Risque Dune Utilisation NON Sécuritaire Risque Prévention Renseignements Généraux ET SUR LE ServiceLisez attentivement tous les avertissements de sécurité Contenu DE LA Boîte Instructions D’ASSEMBLAGE Pression Éléments DE Base D’UNE Laveuse À Pression UtilisationÉléments DE Base DU Moteur Terminologie DES Laveuses À Pression Caractéristiques DE Fonctionnement DE LA Laveuse À PressionRéglage DE LA Pression Endommager la pompeArrêtez le moteur avant de remplacer la buse Utilisation DE LA LanceMise EN Garde Application DES Produits CHIMIQUES/SOLVANTS DE NettoyageDémarrage Si vous appliquez un produit chimique ou une solution deArrêt DE Lappareil Chimiques/solvants de nettoyage » de la sectionPompe EntretienMoteur Nettoyage DU Filtre Dentrée Deau Nettoyage DE LA BusePompe EntreposageAntigel est corrosif et risque dendommager la pompe Rebranchez le fil de la bougie d’allumageProblème Guide DE Dépannage« Choke » Problème Cause Correction D28650 62- FR 63- FR D28650 Responsabilité DE L’ACHETEUR D’ORIGINE utilisateur initial Garantie Limitée