Delta D3500K, D28650 If applying a chemical or cleaning solution, see, Turn water source off

Page 14

STARTING

Prior to starting, refer to your engine manual for proper starting procedures for your engine type.

1.In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to Engine Owners Manual for correct procedure.

2.Check engine oil level. See Engine Owners Manual for correct procedure.

NOTE: There will be a slight amount of oil in the engine from factory testing.

3. Verify the filter screen is in water inlet of pump.

Filter Screen

NOTE: Cone side faces out.

 

4.Connect water source to pump inlet.

NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.

5.Connect high pressure hose to pump outlet.

6.If applying a chemical or cleaning solution, see

How To Apply Chemicals/Cleaning Solvents in

 

High Pressure Hose

Operation section of this manual.

 

 

7.

Turn water source on. NOTE: Failure to do so could

 

 

 

cause damage to the pump.

 

 

8.

Start engine. See Engine Owners Manual for correct

 

 

 

procedure. NOTE: If the engine does not start after

 

 

 

two pulls, pull the trigger to relieve the pressure.

 

 

 

Water

 

9.

Depress trigger on gun to start water flow. NOTE:

 

Source

 

 

Stand on a stable surface and grip gun/spray wand

 

 

 

 

 

 

 

firmly with both hands. Expect the gun to kick when triggered.

 

 

10.Release trigger to stop water flow.

11.Adjust spray for the task being performed by changing quick connect nozzle. See How To Use Spray Wand instructions in this section.

SHUTTING DOWN

1.After each use, if you have applied chemicals, place chemical hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly. NOTE: Failure to do so could cause damage to the pump.

2.Turn engine off. See Engine Owner’s Manual. NOTE: NEVER turn the water off with the engine running.

3.Turn water source off.

4.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.

5.See Storage section in this manual for proper storage procedures.

D28650

14- ENG

Image 14
Contents Struin Ction MAN UAL Or serious injury Or moderate injury Safety Guidelines DefinitionsConsumer Safety Information Death or serious injuryRisk of Explosion or Fire Important Safety InstructionsMaintenance Instructions Risk to BreathingRisk to Fluid Injection Risk of Chemical BurnRisk of HOT Surfaces Risk of Unsafe OperationRisk of Electrical Shock Risk of Injury from Spray Consumer General and Service InformationRead and understand all safety warnings Carton Contents Assembly Instructions ENG D28650 Operating Instructions Throttle Control Lever Controls engine speedPressure Adjustments Pressure Washer TerminologyTo USE Spray Wand Read and Understand ALL Warnings Before Starting Unit To Apply chemicalsTurn water source off If applying a chemical or cleaning solution, seeDepress trigger on gun to start water flow. Note Pump OIL Chart Pump Type OIL Type Capacity MaintenanceHow To Change Pump Oil To Check OilNozzle Cleaning Storage Causecorrection Trouble Shooting GuideProblem Problem Cause Correction Warranty Responsibility of Original Purchaser initial UserAnualm DE Instruccio NES Lesiones serias Resultar en lesiones menores o Moderadas Definiciones DE Normas DE SeguridadInformación DE Seguridad Para EL Consumidor Lesiones serias Causar daños en la propiedadQUÉ Puede Ocurrir Importantes Instrucciones DE SeguridadRiesgo Cómo PrevenirloRiesgo DE Inyección DE Fluido Riesgo DE Funcionamiento Inseguro Información General Y DE Servicio Para EL Consumidor Lea y comprenda todas las advertencias de seguridadContenido DE LA Caja Instrucciones Para EL Armado La lavadora a presión Elementos Básicos DEL Motor Instrucciones DE FuncionamientoElementos Básicos DE UNA Lavadora a Presión Regulación DE LA Presión Terminología DE LA Lavadora a PresiónCaracterísticas DE Funcionamiento DE SU Lavadora a Presión Recalentamiento le ocasionará daños a la bombaMarcha. Detenga el motor antes de cambiar las boquillas USO DE LA Varilla RociadoraCambio de boquillas Cómo Emplear Productos Químicos Y Solventes Para Limpieza Como UN Simple CORTE! ¡Consulte inmediatamente a un médicoMotor no arrancase luego del segundo intento, presione el ArranqueApagado Gatillo para aliviar la presiónBomba MantenimientoMotor Gráfico DE Aceite Para LA BombaLimpieza DE LA Boquilla Cómo Limpiar EL Filtro DE Entrada DEL AguaAlmacenaje Cuando SE EsperenNada o baja Guía DE Diagnóstico DE ProblemasProblema Causa Corrección Del uso inicialNada o baja presión después del uso inicial continuación Problema Goteo de aceite En la bombaNota Garantía Responsabilidad DEL Comprador Original Usuario inicialUidg E DE TILISATEURL’U Ou la mort Mesures DE Sécurité DéfinitionsRenseignements SUR LA Sécurité DU Consommateur Des dommages à la propriétéPrévention Mesures DE Sécurité ImportantesRisque Dexplosion OU D’INCENDIE Risque PAR Inhalation PréventionRisque Risque Dune Utilisation NON Sécuritaire Lisez attentivement tous les avertissements de sécurité Renseignements Généraux ET SUR LE ServiceRisque Prévention Contenu DE LA Boîte Instructions D’ASSEMBLAGE Pression Éléments DE Base DU Moteur UtilisationÉléments DE Base D’UNE Laveuse À Pression Réglage DE LA Pression Caractéristiques DE Fonctionnement DE LA Laveuse À PressionTerminologie DES Laveuses À Pression Endommager la pompeUtilisation DE LA Lance Arrêtez le moteur avant de remplacer la buseApplication DES Produits CHIMIQUES/SOLVANTS DE Nettoyage Mise EN GardeArrêt DE Lappareil Si vous appliquez un produit chimique ou une solution deDémarrage Chimiques/solvants de nettoyage » de la sectionMoteur EntretienPompe Nettoyage DE LA Buse Nettoyage DU Filtre Dentrée DeauAntigel est corrosif et risque dendommager la pompe EntreposagePompe Rebranchez le fil de la bougie d’allumage« Choke » Guide DE DépannageProblème Problème Cause Correction D28650 62- FR 63- FR D28650 Garantie Limitée Responsabilité DE L’ACHETEUR D’ORIGINE utilisateur initial