Section 4: Operation
2.Pull back collar on
3.Select desired spray tip:
•For gentle rinse, select white 40° spray tip.
•To scour surface, select yellow 15° or red 0° spray tip.
•To apply chemical, select black spray tip.
4.Pull back on collar, insert new spray tip and release collar.Tug on spray tip to make sure it is securely in place.
5.For most effective cleaning, keep spray tip from 8 to 24 inches away from cleaning surface. If you get spray tip too close, you may damage cleaning surface. DO NOT get closer than 6 inches when cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a rapid circular pattern. Always start the turbo nozzle at a distance, gradually getting closer to the surface until you get the cleaning force you want.
CAUTION
The turbo nozzle produces an extremely high pressure spray which is capable of removing paint and cutting holes through surfaces if held too close.
•Always make sure the surface you will clean will not be damaged by the high pressure spray by testing in a hidden area.
1.Pull back collar on
2.Pull back on collar, insert turbo nozzle and release collar (Figure 16).Tug on turbo nozzle to make sure it is securely in place.
Figure 16 - Attaching Turbo Nozzle to Nozzle Extension
3.For most effective cleaning, keep turbo nozzle from 8 to 24 inches away from cleaning surface. If you get turbo nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo nozzle.
How to Use the Utility Brush
The utility brush allows you to scrub surfaces with water filtering through the bristles.
To attach the utility brush to the spray gun:
1.Tighten the adapter to the brush base.
2.Remove the nozzle extension from the spray gun, if attached.
3.Attach the brush with the adapter to the spray gun. Tighten by hand (Figure 17).
Figure 17 - Attaching Utility Brush to Spray Gun
NOTE: You must use the adapter to attach the brush to the spray gun.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage the pump.
CAUTION
You must attach all hoses before you start the engine.
•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
To apply detergent follow these steps:
1.Review spray tip use.
2.Prepare detergent solution as required by manufacturer.
3.Hang detergent solution on “J” hook attached to accessory tray, as shown in Figure 18.
Figure 18 — Insert Filter into Container
11