Section
3
Assembly
Required Assembly Tools
• #2 Phillips Screwdriver
ASSEMBLY
IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From Carton
1.Remove parts bag packed with pressure washer.
2.Slice two corners at end of carton from top to bottom so panel can be folded down flat, then remove all packing material.
3.Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
•Main Unit
•Safety Goggles
•Handle
•Plastic Accessory Tray
•High Pressure Hose
•Spray Gun
•Utility Brush and Adapter
•Turbo Nozzle with Quick Connect Fitting
•Nozzle Extension with Quick Connect Fitting and Spray Tip Holder
•Oil Bottle
•Parts Bag (which includes the following):
•Owner’s Manual
•Engine Manual
•Owner’s Registration Card
•Bag containing 4
•Handle Fastening Hardware Kit (which includes):
•Carriage Bolt
•“L” Bolt
•Plastic Knobs (2)
•“J” Hook
•Chemical Hose Clip
•Self Tapping Screws (4)
PREPARING PRESSURE WASHER FOR USE
If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Fill out and send in registration card.
2.Attach accessory tray to handle, then attach handle to main unit.
3.Add oil to engine crankcase.
4.Add fuel to fuel tank.
5.Connect high pressure hose to spray gun and pump.
6.Connect water supply to pump.
7.Attach nozzle extension to spray gun.
8.Select/attach quick connect spray tip to nozzle extension.
Attach Handle and Accessory Tray
NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear.
1.Slide plastic accessory tray onto handle and align holes in accessory tray with holes on handle (Figure 1).
Figure 1 — Attach Accessory Tray
6