Pentair 250, 300 installation manual To Change the Factory Temperature Settings, Time Setting

Temperature & Time Setting (Programming) 24

TO CHANGE THE FACTORY TEMPERATURE SETTINGS:

1.Before changing the temperature, make sure the “Temperature” is in the right window, see pages 24 and 25, if “Time” is displayed, press the MODE key to change to the “Temperature Mode”.

SET

PROGRAM

MODE

2. To change the Pool Temperature setting, press the POOL key.

POOL OFF SPA

3. To Raise or Lower the Pool Temperature setting, press the proper TEMP key until the desired setting is displayed.

		TEMP
	STEP
NOTE: During Programming of the Pool Temperature, the two buttons on the		TEMP
right are used to (IncreaseRaise ) or (DecreaseLower )the display setting numbers.
NOTE: Pool Temperature is now set.
4. You can leave the right window displaying the set “Temperature” or by pressing
the MODE key, you can return to the “Time” Mode.		TEMP
	STEP
NOTE: To re-set the Spa Temperature, follow the above steps 1. through 4.		TEMP
while in the “Spa Heating” Mode.

TIME SETTING

1. Make sure heater is turned “OFF” and not in the POOL or SPA “ON” Mode.

POOL OFF SPA

2. Place the Controller in Programming Mode by depressing the SET and MODE buttons at the same time.

SET

PROGRAM

MODE

NOTE: During Programming of the Time Setting, the two buttons on the right

are used to (IncreaseRaise ) or (DecreaseLower ) the display setting numbers.		TEMP
		TEMP
	STEP

P/N 471593 Rev. C 11-1-01