Pentair 300, 250 installation manual Time SETTING, cont’d, Time Setting Programming

Time Setting (Programming) 25

TIME SETTING, (cont’d.)

3. The first setting, once you enter the Programming Mode, will be the Day. The
Day icon will be flashing. Use the UP or DOWN arrow TEMP keys to locate		TEMP
the appropriate day, then press the SET key. The Day is now set and the Hour	STEP
		TEMP
Time icon will start to flash.
SET
PROGRAM
MODE
4. With Hour Time icon flashing, use the UP/DOWN arrow TEMP keys. Set the		TEMP
Hour to the proper time, “P” will show to the right for PM, and blank for AM.
	STEP
Once the proper Hour is visable, press the SET key. The Minute icon’s will
		TEMP
now start flashing.

SET

PROGRAM

MODE

5.With the Minute icon’s flashing use the UP/DOWN arrow TEMP keys and select the proper Minute setting, then press the SET key. The Day and Time are

now set and the Day icon will be flashing. STEP

SET

PROGRAM

MODE

TEMP

TEMP

6. Press the SET and MODE keys at the same time to return to the Operational Mode.

SET

PROGRAM

MODE

NOTE

During the programming of the CLOCK/DAY function, you touch only the MODE key and a D appears in the upper left corner of the “Current Temperature Display Area”, this represents a delay function and will be used for future functions and accessories to the MiniMax NT Low NOx. When the D appears, simply stop the programmaing, “do NOT touch any key for 30 seconds”, the controller will automatically return to the operating mode, now by pressing the “SET & MODE keys” at the same time, you will re-enter the programming function, and the D icon will disappear.

Rev. C 11-1-01 P/N 471593