Raypak 1287-1758, 2100-4001 manual High & LOW GAS Pressure Switches, Electrical Wiring

Page 15

HIGH & LOW GAS PRESSURE SWITCHES

Pressure switches sense either high or low gas pressure and automatically shut down burners if abnor- mal pressures exsist. Standard on Models 3001-4001.

Heater must be electrically grounded and bonded in accordance with local codes, or, in the absence of local codes, with the latest edition of the National Electrical Code, ANSI/NFPA 70.

PRESSURE

SWITCH

GAS MANIFOLD

Fig. #8929.1

Fig. #8236

 

ELECTRICAL WIRING

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

DANGER - SHOCK HAZARD - Make sure electrical power to the heater is disconnected to avoid potential serious injury or damage to components.

NOTE: If it is necessary to replace any of the original wiring, it must be replaced with 105° C wire or its equivalent.

ELECTRONIC IGNITION

The intermittent ignition device conserves energy by automatically extinguishing the pilot when desired tem- perature is reached. When additional heat is needed, the pilot re-ignites electrically, eliminating the fuel costs of maintaining a constant pilot. To ensure safe operation, the gas valve cannot open until the pilot relights and is confirmed.

Model

w/out lockout

with lockout

 

 

 

926-1826 Natural Gas

Standard

Optional

926-1826Propane

N/A

Standard

2100-4001 Natural Gas

N/A

Standard

2100-4001Propane

N/A

Standard

 

 

 

15

Image 15
Contents Installation and Operating Instructions Raythermtm Contents Base Installation Important NoticeCode Requirements Outdoor Heaters Models ClearancesALL Heaters Outdoor HeatersZ223.1/NFPA VentingconnectionsFIG. #8090.0 GAS Supply ConnectionsPipe Sizing for GAS Connections WaterconnectionsLocation Unitherm Governor Operation Water Pressure SwitchControls Automatic Chlorinators and Chemical FeedersFlow RATES/WATER Connections Models 1287/1336 1758/1826Poolstat Control Page To adjust the temperature Models 2100 thru Temperaturecontrols Highlimits Pool StatLOW Water CUT-OFF High & LOW GAS Pressure Switches Electrical WiringElectronic Ignition Wiring Diagram Models 926 Wiring Diagram MODELS1287-1826 Wiring Diagram Models Wiring Diagram Models Temperaturecontrol Pressure SwitchPressure Switch Adjustment START-UPPROCEDURES Controls InspectionproceduresAfter START-UP Main Burner FlameServicing Procedures Tube Cleaning Procedure TypicalRaypak Tube Cleaning KIT GAS Valve Removal Pilot Removal and CleaningHeat Exchanger Reassembly Burner Drawer RemovalUnitherm Governor Replacement Control Well ReplacementTube Replacement Procedure Procedure for Cleaning Flue GAS PassagewaysWinterization MaintenanceandcareCause Mechanical for Qualified Service Personnel onlyProblem SolutionThis does not take into account heat High Voltage Electrical Electronic Ignition IID IIDReplacement Parts List Page Page Page Models 2100, 2500, 3001, 3500 Page Page Exclusive Warranty Limitation of Liability Heat Exchanger WarrantyParts Replacement To Make Warranty ClaimLitho in U.S.A