6.Set up (LRT-EX only)
ATTACHING THE TRIMMING MECHANISM
(1)Main pipe
(2)Trimming mechanism
(3)Screw hole
(4)Screw
(5)Fastening bolt
1.Remove the screw screwed into the end of the trim- ming mechanism.
2.Insert the end of the trimming mechanism into the main pipe.
3.Line up the hole on the end of the trimming mecha- nism into which the screw is to be inserted with the hole on the main pipe, and screw the screw firmly in.
4.Using a wrench, screw in the bolt provided to fix the trimming mechanism into place.
BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
6.Set up (PS-EX only)
ATTACHING THE PRUNING MECHANISM
(1)
(2)
(3)
(4)
| (5) |
|
(1) | Main pipe | (2) Transmission |
(3) | Screw hole | (4) Fastening bolt |
(5)Bolt
1.Remove the cap on the end of the main pipe.
2.Remove the screw screwed into the end of the trans- mission.
3.Insert the end of the gear case into the main pipe.
4.Line up the hole on the end of the transmission into which the screw is to be inserted with the hole on the main pipe, and screw the screw firmly in.
5.Using a wrench, screw in the bolt provided to fix the mechanism into place.
EXZ2610DL
A standard package contains the items as shown below.
G
B
(1) | Guide bar | (2) | Saw chain |
(3) Transmission | (4) | Sprocket | |
(5) | Chain tension adjust screw | (6) | Nut |
(7) | Chain tensioner nut | (8) | Chain cover |
Install the guide bar and the saw chain on the transmis- sion as follows.
WARNING
The saw chain has very sharp edges. Use protec- tive gloves for safety.
1.Loosen a nut and remove the chain cover.
2.Mount the guide bar then fit the saw chain around the bar and sprocket.
WARNING
Pay attention to the correct direction of the saw chain.
3.Fit the chain tensioner nut into the lower hole of the guide bar, then install the chain cover, and fasten the mounting nut to finger tightness.
(1)Hole
(2)Moving direction
(3)Chain tensioner nut