EXZ2610DL
9. Maintenance (PS-EX only)
OILING PORT
Dismount the guide bar and check the oiling port for clogging.
(1)
(1) Oiling port
GUIDE BAR
Remove sawdust in the bar groove and the oiling port.
(1) Groove (2) Oiling port
(Type: Sprocket nose)
Grease the nose sprocket from the feeding port on the tip of the bar.
(1) Grease port (2) Sprocket
The bar rail should always be a square. Check for wear of the bar rail. Apply a ruler to the bar and the outside of a cutter. If a gap is observed between them, the rail is normal. Otherwise, the bar rail is worn. Such a bar needs to be corrected or replaced.
SPROCKET
Check for extensive wear, and replace it when the teeth are worn over 0.3 mm.
0.3 mm
(1) Sprocket
SAW CHAIN
WARNING
It is very important for smooth and safe operation to keep the cutters always sharp.
Your cutters need to be sharpened when:
•Sawdust becomes
•You need extra force to saw in.
•The cut way does not go straight.
•Vibration increases.
•Fuel consumption increases.
Cutter setting standards:
WARNING
Be sure to wear safety gloves.
Before filing:
•Make sure the saw chain is held securely.
•Make sure the engine is stopped.
•Use a round file of proper size for your chain.
Chain type : 90SG
File size : 5/32 in (4.0 mm)
G B
(1) | Ruler | (2) | Gap |
(3) | No gap | (4) | Chain tilts |