EXZ2610DL
9. Maintenance (PS-EX only)
Place your file on the cutter and push straightforward. Keep the file position as illustrated.
Make sure every cutter has the same length and edge angles as illustrated.
After every cutter has been set, check the depth gauge and file it to the proper level as illustrated.
.025" (0.65 mm)
(4) | Cutter length | (5) Filing angle |
(6) | Side plate angle | (7) Top plate cutting angle |
TRANSMISSION
The reduction gears are lubricated by multipurpose,
Supply new grease every 25 hours of use or more often depending on the job condition.
When adding lubricant, use a grease gun to insert lubri- cant into the three grease nipples located on the trans- mission.
(1) Appropriate gauge checker
(2) Make the shoulder round
(3) Depth gauge standard
WARNING
(1) Grease fitting
Be sure to round off the front edge to reduce the chance of kickback or