Zenoah EXZ2610DL owner manual Operation, Adjusting Handle Position, Adjusting Wheel Height

Page 16

EXZ2610DL

8. Operation

STARTING ENGINE (HE-EX only)

The ZENOAH stick edger is designed for edging lawn in gardens, parks, roadsides and so on.

Before starting the engine, take the operating position and adjust the handle position and the wheel height as necessary.

ADJUSTING HANDLE POSITION

Loosen the handle bracket screws and re-position the handle to your best operating position. Re-tighten the screws.

WARNING

The cutting head will start rotating upon the engine starts.

1.Feed fuel into the fuel tank and tighten the cap se- curely.

(1)

(PS-EX only) Feed the chain oil into the oil tank and tighten the cap securely, too.

(2)

ADJUSTING WHEEL HEIGHT

Loosen the clamp lever and change the wheel height to obtain desired cutting depth.

(1) Fuel

(2) Chain oil

2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects, as it will start rotating upon starting of the engine.

3.Push the primer several times until overflown fuel flows out in the clear tube.

(1) Deep cut

(2) Shallow cut

WARNING

Never adjust wheel height with the engine running.

4. Move the choke lever to the closed position.

(1)

(2)

(3)

(1) Choke lever (2) Close (3) Open

GB-16

Image 16
Contents EXZ2610DL Wear head, eye and ear protection E13*97/68SH2G3*2002/88*0404*00Contents Parts location EXZ2610DL-PUO BC-EX LRT-EX PS-EX HE-EXSpecification BC-EXSymbols on the machine Never modify your machineFor safe operation Working ConditionWorking Circumstance Working PlanBefore Starting Engine Using the ProductStarting the Engine Maintenance If Someone ComesHandling Fuel TransportationGB-10 Set up Mounting Engine Installing HandleConnecting Throttle Wire Connecting Switch WiresSet up BC-EX only Set up LRT-EX only Set up PS-EX onlyAttaching the Trimming Mechanism Balance UnitSet up HE-EX only Put on strap and attach unit to strapFuel and chain oil Adjusting Wheel Height Adjusting Handle PositionOperation Stopping Engine Adjusting Throttle Cable Adjusting Idling SpeedAdjusting the Line Length Operation BC-EX onlyCutting Work Line Head Usage Trimming Grass and WeedsSET UP Operation Optional blade usage BC-EX onlyNy lon line Choose the BladeCutting Method OperationZenoah Controlling Blade Bounce Transporting the UnitAdjusting the angle of the cutting blades Operation LRT-EX onlyOperation PS-EX only Checking oil supplyOperation HE-EX only AIR Filter MaintenanceFuel Filter Replacement Plug is a NGK CMR7H Spark PlugMuffler Spark ArresterMaintenance BC-EX only Procedures to be Performed After Every 100 Hours of USEFor safety reasons, do not use metalreinforced line Refilling Trimming LineMaintenance LRT-EX only Angle TransmissionBlades TransmissionMaintenance PS-EX only Oiling PortGuide BAR Sprocket025 0.65 mm Maintenance HE-EX only Storage Troubleshooting guideDisposal Check Probable Causes ActionLimited warranty