Outdoor Model Installation
Preparing the Cabinet for Installation
1.Remove the lower housing cover (A) by pulling outward on the handle.
2.Remove two phillips screws from the transformer access cover (B). Pull the cover outward from the bottom to remove.
3.Three lower mounting holes (C) are provided. The center hole is open and the outer holes are plugged. If you intend to use the outer holes for installation, carefully drill through the plugs with a 3/16" (5mm) drill bit.
Four wiring access holes are provided in the cabinet base as follows:
(D)- 1/2" (13mm) for power and equipment ground wires.
(E)- 1/2" (13mm) (plugged) for optional Toro Rain Sensor wires.
(F)- 3/4" (19mm) for sprinkler valve wires.
(G)- 1/2" (13mm) (plugged) for optional Toro remote control cable.
4.If planning to install the optional Toro components, remove the plugs as necessary.
9