Toro TMC-212 manual Turn Off Controller Operation

Page 37

Turn Off Controller Operation

When the control dial is turned to the OFF position, controller operation stops immediately. Leaving the control dial in the OFF position enables the controller maintain current time and day, while disabling automatic and manual watering activity.

Turn the control dial to the OFF position.

The word OFF will be displayed for approximately eight minutes. The display will then revert to the automatic status display showing the current time and day.

For extended shutdown of the sprinkler system leave the control dial in the OFF position.

To resume automatic or manual operation, turn the control dial to the RUN position.

35

Image 37

Contents TMC-212 Page Table of Contents Controller Components Controller ComponentsControl Buttons LCD DisplayControl Dial Positions Wire connector for the valve common wire Controller Components Indoor Model Installation Controller InstallationMaster Valve Common Station Wire Valves Connecting the ValvesConnecting the Plug-in Transformer Connecting a Pump Start RelayPage Installing the Cabinet If applicable to the terminal labeled PUMP/MV Connecting a Pump Start Relay Connecting the Power Source Important Do not use ENB and NC switch Connecting a Rain Sensor optionalValve House Getting Started Irrigation System BasicsWatering Program Basics Watering Program Details Setting the Station Run Time Setting Program Start TimesGuidelines for Watering Planning Your Watering ScheduleFilling Out the Watering Schedule Form Example Program a Program B Program C About the Watering Program Memory Programming the ControllerPage Turn the control dial to the Watering Days position Setting an Interval ScheduleSetting an Odd or Even Schedule Using the Day Exclusion Feature Turning Off a Program Setting Program Start Times Setting Pump Start/Master Valve Control Setting Station Run TimesDisplay will be flashing P On Pump On Controller Operation Automatic ModeOperate Watering Programs Manual ModeOperate Selected Stations Cancel Watering Watering Control Features Adjust the Operating Station Run Time Pause WateringRain Delay Feature Season Adjust % Feature Turn Off Controller Operation Clearing the Program Memory To clear and reset memory of a selected programTo clear the memory of all programs Adding a 2-station Expansion Module About Automatic Circuit ProtectionUsing Pump Start/Master Valve and Well Recovery Controls Example Troubleshooting Specifications Toro Promise Limited Three- or Five-year Warranty Warranty