Toro TMC-212 manual Clearing the Program Memory, To clear and reset memory of a selected program

Appendix

Clearing the Program Memory

The user-defined watering program information stored in the TMC-212 memory will be retained for several years. If controller power is lost for more than 24 hours, only the time and date will need to be reset.

If for any reason you wish to clear the user-defined water- ing program information, two methods are provided:

•Clear and reset a selected program to default settings. (Default settings for Program A provide one daily auto- matic watering cycle.)

•Clear and reset all programs simultaneously to off. (All programs are turned off.)

IMPORTANT: These procedures permanently erase all user-defined program information that cannot be recovered once the procedure has been completed.

• To clear and reset memory of a selected program:

36 - Turn the control dial to SEASON ADJUST %.

- Position the PROGRAMS switch setting as necessary.

- Press the NEXT button once; CL will be displayed and begin flashing.

- Press and hold the –/OFFbutton until CL stops flashing (about five seconds). The memory will be cleared and reset to the factory default settings.

5 - To clear the memory of another program, repeat all of the steps starting at step .

- Return the control dial to the RUN position.

• To clear the memory of all programs:

- Turn the control dial to the OFF position.

- Press the NEXT button to access the clear memory function; CL will be displayed and begin flashing.

- Press and hold the –/OFFbutton until CL stops flashing (approximately five seconds). All programs will be cleared simultaneously and turned OFF.

- Return the control dial to the RUN position.