Programming the Controller
About the Watering Program Memory
Once programmed, the
The
If you do not wish to program the controller, you can use the default settings. To enable the
The default watering program settings are as follows:
•Program A has a Calendar watering schedule set to water every day. Programs B and C are turned Off.
•One program start time is set for 5:00 a.m.
•Station run time is set to 10 minutes per station.
•Pump Start/Master Valve circuit is On.
•Pump Start/Master Valve circuit delay is two seconds.
•Well Recovery time is 0 seconds.
•Pump Start/Master Valve circuit is enabled during Well Recovery time.
•Season Adjust is 100% (neutral).
Note: The controller’s programmable memory can be reset to the default settings at any time. See “Clearing the Program Memory” on page 36 for detailed information.
Setting the Current Time and Date
Day |
Month |
Turn the control dial to the CURRENT TIME/DAY position (the hour digits will begin flashing).
Note: The time of day will be displayed in hours and minutes
To increase the display value, press the +/ON button; to decrease, press the
Note: The display characters will change rapidly when holding the +/ON or
Press the NEXT button to select the next portion of the display.
4.Repeat steps and to set the following to set the current minutes, year, month and day.
When the current time and day are displayed, return |
|
the control dial to the RUN position. | 21 |
|