Toro TMC-212 manual Turning Off a Program

Page 28

Turning Off a Program

Note: Turning off a program does not alter or erase a preset watering day schedule. Selecting Off simply places the program on hold until one of the watering day schedules is selected.

- Turn the control dial to the WATERING DAYS position.

- Check the PROGRAMs switch setting. If necessary, reposition the switch to select the desired program.

- Press the +/ON or –/OFFbutton until OFF is flashing.

4.- To turn off another program, repeat steps	and
as needed.

- Return the control dial to the RUN position.

26

Image 28

Contents TMC-212 Page Table of Contents Controller Components Controller ComponentsControl Buttons LCD DisplayControl Dial Positions Wire connector for the valve common wire Controller Components Controller Installation Indoor Model InstallationConnecting the Valves Master Valve Common Station Wire ValvesConnecting a Pump Start Relay Connecting the Plug-in TransformerPage Installing the Cabinet If applicable to the terminal labeled PUMP/MV Connecting a Pump Start Relay Connecting the Power Source Connecting a Rain Sensor optional Important Do not use ENB and NC switchGetting Started Irrigation System Basics Valve HouseWatering Program Basics Watering Program Details Setting Program Start Times Setting the Station Run TimeGuidelines for Watering Planning Your Watering ScheduleFilling Out the Watering Schedule Form Example Program a Program B Program C Programming the Controller About the Watering Program MemoryPage Setting an Interval Schedule Turn the control dial to the Watering Days positionSetting an Odd or Even Schedule Using the Day Exclusion Feature Turning Off a Program Setting Program Start Times Setting Station Run Times Setting Pump Start/Master Valve ControlDisplay will be flashing P On Pump On Automatic Mode Controller OperationOperate Watering Programs Manual ModeOperate Selected Stations Watering Control Features Cancel WateringAdjust the Operating Station Run Time Pause WateringRain Delay Feature Season Adjust % Feature Turn Off Controller Operation Clearing the Program Memory To clear and reset memory of a selected programTo clear the memory of all programs About Automatic Circuit Protection Adding a 2-station Expansion ModuleUsing Pump Start/Master Valve and Well Recovery Controls Example Troubleshooting Specifications Warranty Toro Promise Limited Three- or Five-year Warranty