Toro TMC-212 Setting an Interval Schedule, Turn the control dial to the Watering Days position

Page 25

Setting an Interval Schedule

Turn the control dial to the WATERING DAYS position.

Check the PROGRAMS switch setting. If necessary, reposition the switch to select the desired program.

The current watering schedule will be displayed. If Int (Interval) is not displayed, press the +/ON or –/OFFbutton as needed to select Int.

Press the NEXT button. The current Interval number (1–7) will begin flashing. The day of the week on which the Interval will start will be shown.

To change the Interval number, press the +/ON or –/OFFbutton until the desired number is flashing.

Press the NEXT button. The Interval start day will begin flashing.

To change the Interval start day, press the +/ON button or the –/OFFbutton until the desired day is flashing.

8.To set an Interval schedule for another program, repeat all of the steps beginning at step .

When you have completed setting the Interval schedule for each program (as needed), return the control dial to the RUN position.

Note: The Day Exclusion feature enables you to select any day(s) of the week to be excluded and remain off when using an Interval or Odd/Even watering schedule.

See page 25 for detailed information.

23

Image 25

Contents TMC-212 Page Table of Contents Controller Components Controller ComponentsControl Buttons LCD DisplayControl Dial Positions Wire connector for the valve common wire Controller Components Indoor Model Installation Controller InstallationMaster Valve Common Station Wire Valves Connecting the ValvesConnecting the Plug-in Transformer Connecting a Pump Start RelayPage Installing the Cabinet If applicable to the terminal labeled PUMP/MV Connecting a Pump Start Relay Connecting the Power Source Important Do not use ENB and NC switch Connecting a Rain Sensor optionalValve House Getting Started Irrigation System BasicsWatering Program Basics Watering Program Details Setting the Station Run Time Setting Program Start TimesGuidelines for Watering Planning Your Watering ScheduleFilling Out the Watering Schedule Form Example Program a Program B Program C About the Watering Program Memory Programming the ControllerPage Turn the control dial to the Watering Days position Setting an Interval ScheduleSetting an Odd or Even Schedule Using the Day Exclusion Feature Turning Off a Program Setting Program Start Times Setting Pump Start/Master Valve Control Setting Station Run TimesDisplay will be flashing P On Pump On Controller Operation Automatic ModeOperate Watering Programs Manual ModeOperate Selected Stations Cancel Watering Watering Control FeaturesAdjust the Operating Station Run Time Pause WateringRain Delay Feature Season Adjust % Feature Turn Off Controller Operation Clearing the Program Memory To clear and reset memory of a selected programTo clear the memory of all programs Adding a 2-station Expansion Module About Automatic Circuit ProtectionUsing Pump Start/Master Valve and Well Recovery Controls Example Troubleshooting Specifications Toro Promise Limited Three- or Five-year Warranty Warranty