Genie Z-34, Z-22IC manual Controls, Platform Control Panel

Page 10

Operator's Manual	Fourth Edition • First Printing

Controls

Platform Control Panel

1Drive enable switch

2Drive enable indicator light

3Auxiliary power switch

4Platform level switch

5Horn button

6Primary boom extend/retract switch

7Red Emergency Stop button

8Not used

9Battery charge indicator (option)

10Machine not level indicator light (if equipped)

11Proportional control handle for drive function and thumb rocker for steer function

12Platform overload indicator light (if equipped)

13Drive speed select switch

14Gasoline/LPG models: Choke switch

Diesel models: Glow plug switch (option)

15Engine idle (rpm) select switch

·Rabbit & foot switch: foot switch activated high idle

·Turtle: low idle

·Rabbit: high idle

16Engine start switch

17Gasoline/LPG models: Gasoline/LPG select switch

18Boom function speed controller

19Jib boom up/down switch

20Secondary boom up/down switch

21Primary boom up/down switch

22Turntable rotate switch

23Platform rotate switch

8

Z-34/22 IC

Part No. 1000048

Image 10

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsCSA Fall Hazards Collision Hazards Component Damage HazardDamaged Machine Hazards Battery Safety Burn HazardsExplosion and Fire Hazards Bodily Injury HazardDecal Legend Controls Platform Control PanelGround Control Panel ControlsOperators Manual Pre-operation Inspection FundamentalsPre-operation Inspection Observe and Obey MaintenanceMaintenance Symbols Legend Check the Hydraulic Oil LevelCheck the Engine Oil Level Check the BatteriesScheduled Maintenance Check the Tire PressureFunction Tests Test the Machine Functions At the Ground ControlsTest the Emergency Stop Test the Tilt SensorTest the Horn Test the Foot SwitchAt the Platform Controls Test Machine FunctionsTest the Drive Enable System Test Drive and BrakingTest Limited Drive Speed Test the Lift/Drive Select Function if equippedWorkplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedAuxiliary Controls Starting the EngineEmergency Stop Operation from GroundTo Steer Operation from PlatformTo Drive Driving on a slope To determine the slope gradeDrive Speed Select Drive EnableGenerator if equipped Engine Idle Select rpmFall Protection Platform Overload Indicator Light if equippedMachine Not Level Indicator Light if equipped After Each UseDecals Inspection for Decals with WordsGround Controls Side Chassis Platform Engine SideInspection for Decals with Symbols Ground Controls Side Chassis Platform Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Chassis Securing to Truck or Trailer for TransitSecuring the Platform Lifting Instructions Specifications 34/22 2WD IndustrialSpecifications Range of Motion Distributed By