Genie Z-34, Z-22IC manual Lifting Instructions

Page 36

Operator's Manual	Fourth Edition • First Printing

TRANSPORT AND LIFTING INSTRUCTIONS

Observe and Obey:

Only qualified riggers should rig and lift the machine.

Be sure the crane capacity, loading surfaces and straps or lines are sufficient to withstand the machine weight. See the serial plate for the machine weight.

Lifting Instructions

Fully lower and retract the boom. Fully lower the jib. Remove all loose items on the machine.

Determine the center of gravity of your machine using the table and the picture on this page.

Attach the rigging only to the designated lifting points on the machine. There are four lifting points on the chassis.

Adjust the rigging to prevent damage to the machine and to keep the machine level.

X Axis	35.9 in	91.3 cm

Y Axis	33.3 in	84.7 cm

34

Z-34/22 IC

Part No. 1000048

Image 36

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsCSA Fall Hazards Collision Hazards Component Damage HazardBattery Safety Burn Hazards Explosion and Fire HazardsDamaged Machine Hazards Bodily Injury HazardDecal Legend Controls Platform Control PanelGround Control Panel ControlsOperators Manual Pre-operation Inspection FundamentalsPre-operation Inspection Maintenance Maintenance Symbols LegendObserve and Obey Check the Hydraulic Oil LevelCheck the Engine Oil Level Check the BatteriesScheduled Maintenance Check the Tire PressureFunction Tests At the Ground Controls Test the Emergency StopTest the Machine Functions Test the Tilt SensorTest the Foot Switch At the Platform ControlsTest the Horn Test Machine FunctionsTest the Drive Enable System Test Drive and BrakingTest Limited Drive Speed Test the Lift/Drive Select Function if equippedWorkplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedStarting the Engine Emergency StopAuxiliary Controls Operation from GroundOperation from Platform To SteerTo Drive Driving on a slope To determine the slope gradeDrive Enable Generator if equippedDrive Speed Select Engine Idle Select rpmPlatform Overload Indicator Light if equipped Machine Not Level Indicator Light if equippedFall Protection After Each UseDecals Inspection for Decals with WordsGround Controls Side Chassis Platform Engine SideInspection for Decals with Symbols Ground Controls Side Chassis Platform Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring to Truck or Trailer for Transit Securing the ChassisSecuring the Platform Lifting Instructions Specifications 34/22 2WD IndustrialSpecifications Range of Motion Distributed By