Genie Z-34, Z-22IC manual Function Tests, Do Not Operate Unless

Page 18

Operator's Manual	Fourth Edition • First Printing

Function Tests

Do Not Operate Unless:

You learn and practice the principles of safe machine operation contained in this operator's manual.

1Avoid hazardous situations.

2Always perform a pre-operation inspection.

3Always perform function tests prior to use.

Know and understand the function tests before going on to the next section.

4Inspect the workplace.

5Only use the machine as it was intended.

Fundamentals

The function tests are designed to discover any malfunctions before the machine is put into service. The operator must follow the step-by-step instructions to test all machine functions.

A malfunctioning machine must never be used. If malfunctions are discovered, the machine must be tagged and removed from service. Repairs to the machine may only be made by a qualified service technician, according to the manufacturer's specifications.

After repairs are completed, the operator must perform a pre-operation inspection and function tests again before putting the machine into service.

16

Z-34/22 IC

Part No. 1000048

Image 18

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsCSA Fall Hazards Collision Hazards Component Damage HazardDamaged Machine Hazards Battery Safety Burn HazardsExplosion and Fire Hazards Bodily Injury HazardDecal Legend Controls Platform Control PanelGround Control Panel ControlsOperators Manual Pre-operation Inspection FundamentalsPre-operation Inspection Observe and Obey Maintenance Maintenance Symbols Legend Check the Hydraulic Oil LevelCheck the Engine Oil Level Check the BatteriesScheduled Maintenance Check the Tire PressureFunction Tests Test the Machine Functions At the Ground ControlsTest the Emergency Stop Test the Tilt SensorTest the Horn Test the Foot SwitchAt the Platform Controls Test Machine FunctionsTest the Drive Enable System Test Drive and BrakingTest Limited Drive Speed Test the Lift/Drive Select Function if equippedWorkplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedAuxiliary Controls Starting the EngineEmergency Stop Operation from GroundOperation from Platform To SteerTo Drive Driving on a slope To determine the slope gradeDrive Speed Select Drive EnableGenerator if equipped Engine Idle Select rpmFall Protection Platform Overload Indicator Light if equippedMachine Not Level Indicator Light if equipped After Each UseDecals Inspection for Decals with WordsGround Controls Side Chassis Platform Engine SideInspection for Decals with Symbols Ground Controls Side Chassis Platform Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring to Truck or Trailer for Transit Securing the ChassisSecuring the Platform Lifting Instructions Specifications 34/22 2WD IndustrialSpecifications Range of Motion Distributed By