Genie Z-34, Z-22IC manual Check the Engine Oil Level, Check the Batteries

Page 16

Operator's Manual	Fourth Edition • First Printing

MAINTENANCE

Check the Engine Oil Level			Check the Batteries

Maintaining the proper engine oil level is essential to good engine performance and service life. Operating the machine with an improper oil level can damage engine components.

Check the oil level with the engine off.

1 Check the oil level dipstick. Add oil as needed.

Kubota Engine DF-752-E2

Oil type	10W-30

Kubota Engine D-905 B-22

Oil type	10W-30

Perkins Engine 404C-11

Oil type	15W-40

Proper battery condition is essential to good engine performance and operational safety. Improper fluid levels or damaged cables and connections can result in engine component damage and hazardous conditions.

Bodily injury hazard. Batteries contain acid. Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water.

1Put on protective clothing and eye wear.

2Be sure that the battery cable connections are tight and free of corrosion.

3Be sure that the battery hold-down bracket is tight.

4Remove the battery vent caps.

5Check the battery acid level. If needed, replenish with distilled water to the bottom of the battery fill tube. Do not overfill.

6Install the vent caps.

14

Z-34/22 IC

Part No. 1000048

Image 16

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsCSA Fall Hazards Collision Hazards Component Damage HazardBattery Safety Burn Hazards Explosion and Fire HazardsDamaged Machine Hazards Bodily Injury HazardDecal Legend Controls Platform Control PanelGround Control Panel ControlsOperators Manual Pre-operation Inspection FundamentalsPre-operation Inspection Maintenance Maintenance Symbols LegendObserve and Obey Check the Hydraulic Oil LevelCheck the Engine Oil Level Check the BatteriesScheduled Maintenance Check the Tire PressureFunction Tests At the Ground Controls Test the Emergency StopTest the Machine Functions Test the Tilt SensorTest the Foot Switch At the Platform ControlsTest the Horn Test Machine FunctionsTest the Drive Enable System Test Drive and BrakingTest Limited Drive Speed Test the Lift/Drive Select Function if equippedWorkplace Inspection Workplace InspectionOperating Instructions Only use the machine as it was intendedStarting the Engine Emergency StopAuxiliary Controls Operation from GroundTo Steer Operation from PlatformTo Drive Driving on a slope To determine the slope gradeDrive Enable Generator if equippedDrive Speed Select Engine Idle Select rpmPlatform Overload Indicator Light if equipped Machine Not Level Indicator Light if equippedFall Protection After Each UseDecals Inspection for Decals with WordsGround Controls Side Chassis Platform Engine SideInspection for Decals with Symbols Ground Controls Side Chassis Platform Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Chassis Securing to Truck or Trailer for TransitSecuring the Platform Lifting Instructions Specifications 34/22 2WD IndustrialSpecifications Range of Motion Distributed By