Genie TMZ-34, TMZ-19 manual Reporting Safety Defects, Genie Industries PO Box Redmond, WA

Page 37

Fourth Edition • First Printing

Operator's Manual

 

 

 

 

 

 

Reporting Safety Defects

Genie Industries

PO Box 97030

Redmond, WA 98073-9730

Reporting Safety Defects

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to Genie Industries.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in any individual problems between you, your dealer or Genie Industries.

To contact NHTSA you may either call the Auto Safety Hotline toll-free at 1-800-424-9393 (366-0123 in Washington DC area) or write to:

NHTSA

U.S. Department of Transportation

4007th Street SW, (NSA-11) Washington DC 20590

You can also obtain information about motor vehicle safety from the Hotline.

Part No. 97866

GenieTMZ-34/19

35

Image 37 Contents
Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsBodily Injury Hazard Component Damage Hazards Collision HazardsLifting Hazards Explosion and Fire HazardsDecal Legend Towing HazardsMaterial Lifting Configuration Collision Hazards Personnel Lifting Configuration Tip-over HazardsFall Hazards Collision HazardExplosion Hazards Battery Safety Burn HazardsTip-over Hazard Lifting HazardPlatform Control Panel ControlsStop Ground Control Panel manual outriggers Ground Control Panel hydraulic outriggers Stop Stop Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionMaintenance Symbols Legend MaintenanceObserve and Obey Check the Hydraulic Oil LevelCheck the Tires and Wheels MaintenanceCheck the Batteries Scheduled MaintenanceFunction Tests Set upTest Emergency Stop At the Ground ControlsTest Outrigger Interlock Test the Boom Functions At the Platform ControlsTest the Tilt Sensor Test the HornGround Control Panels Test Boom Functions and Function Enable Workplace Inspection Workplace InspectionOnly use the machine as it was intended Operating InstructionsOperation from Ground Emergency StopOperation from Platform To Position PlatformManual Turntable Rotation Manual LoweringFall Protection TransportMoving Machine Without a Tow Vehicle Towing InformationBacking Up with Trailer If equipped with surge brake After Each Use Material Lifting Configuration Set up Material Lifting Configuration Observe and Obey Dry Battery Filling Charging Instructions Battery and Charger Instructions Observe and Obey To Charge Battery Voltage ConversionDecal Inspection DecalsGround PowerControls SideAnsi & CSA SpecificationsReporting Safety Defects Reporting Safety DefectsGenie Industries PO Box Redmond, WA