Genie TMZ-34, TMZ-19 manual Test Boom Functions and Function Enable

Fourth Edition • First Printing Operator's Manual

Test the Tilt Sensor

12 Raise the jib boom approximately 6 in / 15 cm. Raise the primary boom approximately 6 in / 15 cm off the boom rest. Raise the secondary boom approximately 6 in / 15 cm off the boom rest.

13 Locate the tilt sensor on the chassis near the ground controls.

14 Press down one side of the tilt sensor and place the tilt sensor test tool under one of the posts.

Result: The alarm, located in the platform, should sound after 1 second.

15 Test all ground and platform control functions.

Result: The primary boom up, the secondary boom up and the jib boom up functions should not operate. The primary boom down, the secondary boom down, the jib boom down and the turntable rotate functions should operate normally.

16 Remove the tilt sensor test tool.

17 Turn the key switch to platform control.

FUNCTION TESTS

At the Platform Controls

18Pull out the platform red Emergency Stop button to the on position.

Test Emergency Stop

19Push in the platform red Emergency Stop button to the off position.

Result: All ground and platform control functions should not operate.

Test the Horn

20Pull out the red Emergency Stop button to the on position.

21Push the horn button.

Result: The horn should sound.

Test Boom Functions and Function Enable

22Do not push a function enable button. Attempt to activate each boom function button.

Result: All boom functions should not operate.

23Push and hold the blue function enable button. Activate each boom function button.

Result: Primary boom up, secondary boom up, jib boom up and turntable rotate right should all function.

24Push and hold the yellow function enable button. Activate each boom function button.

Result: Primary boom down, secondary boom down, jib boom down and turntable rotate left should all function.

Part No. 97866 GenieTMZ-34/19 23