Genie 43650, S-80, S-85 At the Platform Controls, Test Auxiliary Controls, Test the Service Horn

Page 20

Operator's Manual

Second Edition· Fifth Printing

 

 

 

 

FUNCTION TESTS

Test Auxiliary Controls

22Turn the key switch to ground control and shut the engine off.

23Pull out the red Emergency Stop button to the ON position.

24Simultaneously hold the auxiliary power switch on and activate each boom function toggle switch.

Note: To conserve battery power, test each function through a partial cycle.

Result: All boom functions should operate.

At the Platform Controls

Test Emergency Stop

25Turn the key switch to platform control and restart the engine.

26Push in the platform red Emergency Stop button to the OFF position.

Result: The engine should turn off and all functions should not operate.

27Pull out the red Emergency Stop button and restart the engine.

Test the Hydraulic Oil Return Filter

28Move the engine idle select switch to high idel (rabbit symbol).

29Locate and check the hydraulic filter condition indicator.

Result: The filter should be operating with the plunger in the green area.

30Move the engine idle select switch to foot switch activated high idle (rabbit and foot switch symbol).

Test the Service Horn

31 Push the horn button.

Result: The service horn should sound.

Test the Foot Switch

32Push in the platform Emergency Stop button to the OFF position.

33Pull out the Emergency Stop button to the ON position but do not start the engine.

34Press down the foot switch and attempt to start engine by moving the start toggle switch to either side.

Result: The engine should not start.

35Do not press down the foot switch and restart engine.

36Move the lift/drive select switch to the lift position (if equipped).

37Do not press down the foot switch. Then test each machine function.

Result: The machine functions should not operate.

18

Genie S-80 & Genie S-85

Part No. 43650

Image 20
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum allowable side force-ANSI & CSA Maximum allowable manual force CEFall Hazards Bodily Injury HazardCollision Hazards Component Damage HazardsDecal Legend Explosion and Fire HazardsDamaged Machine Hazards Controls Ground Control PanelPlatform Control Panel Controls Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionMaintenance Maintenance Symbols LegendObserve and Obey Check the Engine Oil LevelHydraulic oil specifications Check the Hydraulic Oil LevelDeutz F4L 1011F Engine Oil Capacity Including filter Perkins 704-30 Engine Oil Capacity Including filterFull mark Scheduled Maintenance Maintenance Inspection ReportCheck the Tire Pressure ScheduleFunction Tests At the Ground ControlsTest Emergency Stop Test the Extendable AxlesTest the Machine Functions Test the Tilt SensorTest the Service Horn Test the Foot SwitchAt the Platform Controls Test Auxiliary ControlsTest Drive and Braking Test Machine FunctionsTest the Steering Test the Drive Enable System Test Limited Drive SpeedTest the Lift/Drive Select Switch if equipped Work Place Inspection Work Place InspectionOperating Instructions Starting the EngineEmergency Stop Only use the machine as it was intendedAuxiliary Controls Extendable AxlesOperation from Ground To Position PlatformDrive Enable Operation from PlatformTo Steer To DriveEngine Idle Select rpm Check Engine Light if equippedStopping the Engine After Each UseSecuring to Truck or Trailer for Transit Free-wheel Configuration for WinchingTransport Instructions Decal Description Quantity DecalsDecal Inspection Ground Controls Side Drive Chassis Platform Engine SideDrive speeds SpecificationsModel Distributed By