Genie 43650, S-80, S-85 manual Explosion and Fire Hazards, Damaged Machine Hazards, Decal Legend

Page 8

Operator's Manual

Second Edition· Fifth Printing

 

 

 

 

SAFETY RULES

Explosion and Fire Hazards

Do not start engine if you smell or detect liquid petroleum gas (LPG), gasoline, diesel fuel or other explosive substances.

Do not refuel machine with engine running.

Refuel machine and charge battery only in an open, well-ventilated area away from sparks, flames and lighted tobacco.

Do not operate the machine in hazardous locations or locations where potentially flammable or explosive gases or particles may be present.

Damaged Machine Hazards

Do not use a damaged or malfunctioning machine.

Conduct a thorough pre-operation inspection of the machine and test all functions before each work shift. Immediately tag and remove from service a damaged or malfunctioning machine.

Be sure all maintenance has been performed as specified in this manual and the Genie S-80 & Genie S-85 Service Manual.

Be sure all decals are in place and legible.

Be sure that the operator’s, the safety and the responsibilities manuals are complete, legible and in the storage container located on the platform.

Decal Legend

Genie product decals use symbols, color coding and signal words to identify the following:

Safety alert symbol—used to alert personnel to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.

Red—used to indicate the presence of an imminently hazardous situation which, if not avoided, will result in death or serious injury.

Orange—used to indicate the presence of a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Yellow with safety alert symbol— used to indicate the presence of a potentially hazardous situation which, if not avoided, may cause minor or moderate injury.

Yellow without safety alert symbol—used to indicate the presense of a potentially hazardous situation which, if not avoided, may result in property damage.

Green—used to indicate operation or maintenance information.

6

Genie S-80 & Genie S-85

Part No.43650

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum allowable side force-ANSI & CSA Maximum allowable manual force CEFall Hazards Bodily Injury HazardCollision Hazards Component Damage HazardsDecal Legend Explosion and Fire HazardsDamaged Machine Hazards Controls Ground Control PanelPlatform Control Panel Controls Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionMaintenance Maintenance Symbols LegendObserve and Obey Check the Engine Oil LevelHydraulic oil specifications Check the Hydraulic Oil LevelDeutz F4L 1011F Engine Oil Capacity Including filter Perkins 704-30 Engine Oil Capacity Including filterFull mark Scheduled Maintenance Maintenance Inspection ReportCheck the Tire Pressure ScheduleFunction Tests At the Ground ControlsTest Emergency Stop Test the Extendable AxlesTest the Machine Functions Test the Tilt SensorTest the Service Horn Test the Foot SwitchAt the Platform Controls Test Auxiliary ControlsTest Drive and Braking Test Machine FunctionsTest the Steering Test the Drive Enable System Test Limited Drive SpeedTest the Lift/Drive Select Switch if equipped Work Place Inspection Work Place InspectionOperating Instructions Starting the EngineEmergency Stop Only use the machine as it was intendedAuxiliary Controls Extendable AxlesOperation from Ground To Position PlatformDrive Enable Operation from PlatformTo Steer To DriveEngine Idle Select rpm Check Engine Light if equippedStopping the Engine After Each UseSecuring to Truck or Trailer for Transit Free-wheel Configuration for WinchingTransport Instructions Decal Description Quantity DecalsDecal Inspection Ground Controls Side Drive Chassis Platform Engine SideDrive speeds SpecificationsModel Distributed By
Top Page Image Contents