Genie S-80, S-85, 43650 manual Fall Hazards, Bodily Injury Hazard

Page 6

Operator's Manual

Second Edition· Fifth Printing

 

 

 

 

SAFETY RULES

Do not place or attach overhanging loads to any part of this machine.

Do not place ladders or scaffolds in platform or against any part of this machine.

Do not use machine on a moving or mobile surface or vehicle.

Be sure all tires are in good condition, air-filled tires are properly inflated and lug nuts are properly tightened.

Models with 750 lb (340 kg) Capacity: Do not use air-filled tires. Models are equipped with foam- filled tires. The wheel weight and the proper counterweight configuration are critical for machine stability.

Do not use the platform controls to free a platform that is caught, snagged or otherwise prevented from normal motion by an adjacent structure. All personnel must be removed from the platform before attempting to free the platform using the ground controls.

Fall Hazards

Occupants must wear a safety belt or harness in accordance with governmental regulations. Attach lanyard to anchor provided in platform.

Do not sit, stand or climb on the platform guard rails. Maintain a firm footing on the platform floor at all times.

Do not climb down from the platform when raised.

Keep the platform floor clear of debris.

Lower the platform entry mid-rail or close the entry gate before operating.

Bodily Injury Hazard

Do not operate the machine with a hydraulic oil or air leak. An air or hydraulic leak can penetrate and/or burn skin.

Always operate machine in a well-ventilated area to avoid carbon monoxide poisoning.

4

Genie S-80 & Genie S-85

Part No.43650

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsMaximum allowable side force-ANSI & CSA Maximum allowable manual force CEFall Hazards Bodily Injury HazardCollision Hazards Component Damage HazardsExplosion and Fire Hazards Damaged Machine HazardsDecal Legend Controls Ground Control PanelPlatform Control Panel Controls Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceMaintenance Symbols Legend Check the Engine Oil LevelDeutz F4L 1011F Engine Oil Capacity Including filter Hydraulic oil specificationsCheck the Hydraulic Oil Level Perkins 704-30 Engine Oil Capacity Including filterFull mark Check the Tire Pressure Scheduled MaintenanceMaintenance Inspection Report ScheduleTest Emergency Stop Function TestsAt the Ground Controls Test the Extendable AxlesTest the Machine Functions Test the Tilt SensorAt the Platform Controls Test the Service HornTest the Foot Switch Test Auxiliary ControlsTest Machine Functions Test the SteeringTest Drive and Braking Test the Drive Enable System Test Limited Drive SpeedTest the Lift/Drive Select Switch if equipped Work Place Inspection Work Place InspectionEmergency Stop Operating InstructionsStarting the Engine Only use the machine as it was intendedOperation from Ground Auxiliary ControlsExtendable Axles To Position PlatformTo Steer Drive EnableOperation from Platform To DriveStopping the Engine Engine Idle Select rpmCheck Engine Light if equipped After Each UseFree-wheel Configuration for Winching Transport InstructionsSecuring to Truck or Trailer for Transit Decals Decal InspectionDecal Description Quantity Ground Controls Side Drive Chassis Platform Engine SideSpecifications ModelDrive speeds Distributed By
Top Page Image Contents