Genie S-80, S-85, 43650 manual Controls, Ground Control Panel

Page 9

Second Edition · Fifth Printing	Operator's Manual

Controls

Ground Control Panel

1Platform rotate switch

2Turntable rotate switch

3Boom up/down switch

4Boom extend/retract switch

5not used

6Key switch for platform/off/ground selection

7Auxiliary power switch

8Gasoline/LPG models: Water temperature gauge

Deutz Diesel models: Oil temperature gauge

9Oil pressure gauge

10Voltage gauge

11Emergency Stop button

12Hour meter

13Gasoline/LPG models: Check engine light

Deutz Diesel models: Glow plug switch (option)

14Function enable switch

15Engine start switch

1615A breaker for engine electrical circuits

17Gasoline/LPG select switch

1815A breaker for control electrical circuits

19S-85 only: Jib boom up/down switch

20Platform level switch

Part No. 43650

Genie S-80 & Genie S-85

Image 9

Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsMaximum allowable manual force CE Maximum allowable side force-ANSI & CSABodily Injury Hazard Fall HazardsComponent Damage Hazards Collision HazardsExplosion and Fire Hazards Damaged Machine HazardsDecal Legend Ground Control Panel ControlsPlatform Control Panel Controls Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionMaintenance Symbols Legend MaintenanceObserve and Obey Check the Engine Oil LevelCheck the Hydraulic Oil Level Hydraulic oil specificationsDeutz F4L 1011F Engine Oil Capacity Including filter Perkins 704-30 Engine Oil Capacity Including filterFull mark Maintenance Inspection Report Scheduled MaintenanceCheck the Tire Pressure ScheduleAt the Ground Controls Function TestsTest Emergency Stop Test the Extendable AxlesTest the Tilt Sensor Test the Machine FunctionsTest the Foot Switch Test the Service HornAt the Platform Controls Test Auxiliary ControlsTest Machine Functions Test the SteeringTest Drive and Braking Test Limited Drive Speed Test the Drive Enable SystemTest the Lift/Drive Select Switch if equipped Work Place Inspection Work Place InspectionStarting the Engine Operating InstructionsEmergency Stop Only use the machine as it was intendedExtendable Axles Auxiliary ControlsOperation from Ground To Position PlatformOperation from Platform Drive EnableTo Steer To DriveCheck Engine Light if equipped Engine Idle Select rpmStopping the Engine After Each UseFree-wheel Configuration for Winching Transport InstructionsSecuring to Truck or Trailer for Transit Decals Decal InspectionDecal Description Quantity Engine Side Ground Controls Side Drive Chassis PlatformSpecifications ModelDrive speeds Distributed By