Unpacking Unit
1.Remove all screws and staples from the crete.
2.Holding sides of the crete firmly, lift top of the crate up and set itaside. Avoid tire punctures.
3.Remove and discard plastic bag covering the unit.
4.Lift the rear of the vehicle off the crate. Repeat for the front. This may require two people.
5.Remove plastic bag and its contents (owner's manual, ignition keys etc.) that are packed on the steering shaft.
6.Refer to Figure 7 in Owner'sManual for location of the parking brake. Check to make sure that the
parking brake is disengaged so that the vehicle can be rolled forward.
Loose Parts
1.Remove loose parts from the grass catcher and/or the crate very carefully. Compare with list below and part illustrations in Figure 1.
•Mulch plug
•
•Plastic bag carrying operator'smanual and two ignition keys(not shown)
1.Lower the cutting deck to the lowest position by sliding the deck lift lever to the appropriate slot indicated bythe label. Refer to Figure 7 and description on page 9 for more details.
2.Remove the thumb screw and flat washer attaching the two ends of the grass catcher chute to the deck. Slide the grass catcher chute out of the vehicle housing; remove and save the hardware.
3.Place the
4.Insert a thumb screw and a flat washer, removed in step 2, through the left hole on the chute and the
corresponding hole on the deck. See Figure 2. Thread the screw a few turns to secure, but do not
tighten at this time.
5.Repeat on the dght side. Tighten both screws.
Thumb
Figure 2
|
|
| Attaching Mulch Plug | |
|
|
| To mulch grass and recirculate clippings back to the | |
|
|
| lawn, attach the mulching plug to the deck. | |
|
|
| 1. | Lower the cutting deck to the lowest position. |
|
|
| 2. | Remove the thumb screw and flat washer attaching |
| Figure 1 |
|
| the two ends of the discharge chute to the deck. |
|
|
| (Refer to Figure 2 for the discharge chute | |
|
|
|
| |
NOTE: Any reference in this manual to RIGHT, LEFT, |
| Slide the discharge chute out of the deck housing; | ||
TOP and BOTTOM | of the tractor is observed from the |
| remove and save the hardware. | |
operator's position when sitting on the vehicle seat. | 3. | Place the mulch plug on the deck so that the two | ||
Attaching | Chute |
| holes on its two ends align with the two holes on the | |
4. | deck where the discharge chute was attached. | |||
|
|
| Insert thumb screw and fiat washer, removed in | |
WARNING: | Do not mow grass if any one of |
| step 2, through the left hole on the mulch plug and | |
| corresponding hole on the deck. See Figure 3. | |||
the grass catcher chute, discharge chute or |
| |||
| Thread the screw a few turns to secure, but do not | |||
mulch plug is not firmly installed on the lawn |
| |||
| tighten at this time. | |||
utilityvehicle. |
|
| ||
| 5. | Repeat on the right side. Tighten both screws. | ||
|
|
|