Land Pride | Table of Contents |
Section 2: Options, Assembly & Set-Up
Blade Tilting Cylinder
Refer to Figure 2-3:
IMPORTANT: Do not remove shipping block from the blade tilt housing until all cylinders and/or ratchet jack and manual links have been installed.
IMPORTANT: Assemble base end of cylinder to the lug located on the blade pivot as shown.
1.Install two 90 degree elbows (#4) into the hydraulic cylinder ports (#3) as shown. Tighten as needed.
2.Screw 140" long hydraulic hoses (#5) into elbows (#4) and tighten.
3.Thread adapter fittings (#6) to the other end of the hydraulic hoses and tighten. (Hydraulic couplings not furnished.)
4.Attach hydraulic cylinder (#3) to the lugs at the back of the blade with clevis pins (#2). Make sure hydraulic ports are positioned on the back and the cylinder base is mounted to the center lug as shown.
5.Secure clevis pins with hair pin cotters (#1).
6.Remove shipping block at this time.
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
25504
Hydraulic Blade Tilting
Figure
5/21/07 | RBT55120 Rear Blades | 11 |