Land Pride RBT55120 manual Tractor Requirements, Assembly & Set-Up

Land Pride Table of Contents

Section 1: Assembly & Set-Up

Tractor Requirements

Weight & Horsepower

Tractor rating should be between 90 - 180 horsepower. Tractors outside this range must not be used.

NOTE: Ballast may need to be added to your tractor to maintain steering control. Refer to your tractor’s operator manual to determine if additional ballast is needed.

3-Point Hitch Assembly

A 3-Point Category ll or lII hitch is required. The lower 3-Point arms of the 3-Point hitch must be stabilized to prevent side-to-side movement. Most tractors have sway blocks or adjustable chains for this purpose.

Hydraulic Outlets

The number of required hydraulic duplex outlets at the tractor is dependent upon how the 3-Way Rear Blade is set-up.

•No outlets are required if the 3-Way Rear Blade is set-up with manual links and ratchet jacks only.

•One to three duplex outlets are required if the 3-Way Rear Blade is set-up with any one or more of the following hydraulic cylinders; Offset Cylinder, Tilt Cylinder and Angle Cylinder. Each cylinder will require a duplex outlet at the tractor.

•A fourth duplex outlet is required if a gauge wheel is purchased with a hydraulic cylinder.

A Selector Valve Kit may be purchased through your local Land Pride dealer if your tractor does not have the required number of duplex outlets. This kit provides a way to operate 2 cylinders with one outlet, thereby reducing the number of outlets at the tractor by one.

Land Pride Selector Valve Kit

Part No. Part Description

300-154A DOUBLE SELECTOR VALVE ASSY

For use with two duplex outlets. Will allow operation of 3 cylinders with 2 tractor outlets.

5/21/07 RBT55120 Rear Blades 301-172M 7