Land Pride RBT55120 manual Skid Shoe, End Plates, Wear Plates

Land Pride Table of Contents

Section 2: Options, Assembly & Set-Up

Skid Shoe

Refer to Figure 2-7:

The skid shoes are attached to both ends of the blade to help prevent damage to the surface of the ground by the blade.

Kit Bundle

301-110A SKID SHOE ASSEMBLY

1.Attach skid shoe mount (#4) with two 1/2"-13 x 4 1/2" GR5 hex head cap screw (#1), flat washers (#8), spring lock washers (#6) and hex nuts (#7). Tighten hardware to the correct torque.

2.Insert skid shoe (#3) into skid shoe mount (#4). Secure with clevis pin (#2) and hair pin cotter (#5).

3.Repeat steps 1 & 2 for the other side.

12549

Skid Shoe Assembly

Figure 2-7

End Plates

Refer to Figure 2-8:

End plates are attached to both ends of the blade, eliminating spillage when moving snow or loose material.

Kit Bundle

301-147A END PLATES

NOTE: Alternate tightening of bolts when installing mounting hardware. Some deflection may occur in moldboard.

1.Attach right hand end plate (#3) to the moldboard as shown with two 5/8"-11 x 2" GR5 hex head cap screws (#4), spring lock washer (#7) and hex nuts (#8). Draw hex nuts up snug. Do not tighten.

2.Attach side plate support strap (#2) with two 1/2”-13 x 1 1/4” GR5 hex head cap screws (#1), lock washers (#5) and hex nuts (#6). Draw hex nuts up snug. Do not tighten.

3.First tighten hex nuts (#8) to the correct torque and then next nuts (#6) last.

4.Repeat steps 1 and 3 for the left hand end plate.

.

12550

End Plate Assembly

Figure 2-8

Wear Plates

Refer to Figure 2-9:

Hardened wear plates are attached to both ends of the blade. These plates are designed to protect moldboard edges when blade is used for digging ditches or working abrasive material.

Kit Bundle

301-148A HARDENED WEAR PLATES (PAIR)

1.Attach wear plate (#2) to the moldboard with 5/8”-11 x 2” GR52 round head square neck bolt (#1), lock washer (#3) and hex nut (#4). Tighten hardware to correct torque.

2.Repeat step 1 for the left hand wear plate.

Wear Plate Assembly

Figure 2-9

5/21/07 RBT55120 Rear Blades 301-172M 15