Land Pride
Section 3: Adjustments
Table of Contents
Refer to Figure 2-3 on page 11:
The blade end can be tilted hydraulically with the tilt cylinder by as much as 30 degrees.
1.If the tilting cylinder is attached to the selector valve, make certain the valve lever is set to operate that cylinder.
2.Operate tractor control lever to change blade tilt by as much as 30 degrees.
Gauge Wheel
Refer to Figure 2-5 on page 13:
The gauge wheel provides accurate depth control when grading, leveling or terracing. The height of the gauge wheel is determined by adjusting the ratchet jack or hydraulic cylinder.
IMPORTANT: The top center
Manual Gauge Wheel Adjustment
1.Set ratchet lock and pump lever back and forth to raise the gauge wheel.
2.Reposition ratchet lock and pump lever back and forth to lower gauge wheel.
Hydraulic Gauge Wheel Adjustment
1.If the gauge wheel cylinder is attached to the selector valve, make certain the valve lever is set to operate that cylinder.
2.Operate tractor control lever to change gauge wheel height up or down.
5/21/07 | RBT55120 Rear Blades | 17 |