Table of Contents
Section 2: Options, Assembly & Set-Up
Land Pride
Manual Offset, Angling and Tilting
The manual links and ratchet jack may be used in place of the hydraulic cylinders.
IMPORTANT: Do not remove shipping block from the blade tilt housing until all cylinders and/or ratchet jack and manual links have been installed.
Manual Blade Angling
Manual Blade Offset
Refer to Figure 2-4:
9.Attach blade offset links (#3 and #4) to the left side of the Rear Blade as shown with two 1" clevis pins (#1). Secure with hair pin cotters (#5).
10.Adjust offset angle by removing hitch pin (#2) and moving outer link (#3) to a different hole. Replace hitch pin and secure with hair pin cotter (#5).
Refer to Figure 2-4:
7.Attach blade angling links (#3 and #4) to the right side of the Rear Blade as shown with two 1" clevis pins (#1). Secure with hair pin cotters (#5).
8.Adjust blade angle by removing hitch pin (#2) and moving outer link (#3) to a different hole. Replace hitch pin and secure with hair pin cotter (#5).
Manual Blade Tilting
Refer to Figure 2-4:
1.Attach ratchet jack (#6) to the back side of the Rear Blade as shown with two 1" clevis pins (#1). Secure with hair pin cotters (#5).
2.Adjust blade tilt by setting the lock on the ratchet lever and pumping the lever back and forth to raise one end of the blade higher than the other end. Reposition ratchet lock and pump lever back and forth to tilt blade in the opposite direction.
3.Remove shipping block after ratchet jack (#6) has been installed.
Blade Offset
Blade Angling
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
Blade Tilting
25508
Manual Offset, Angling and Tilting
Figure
12 RBT55120 Rear Blades | 5/21/07 |